Recent content by Six Shooter

Re: Center Cap lock size Do you have the part number from McGard by chance?

Long story short...the mechanic broke one of the center cap locks so I need a new set. Does anyone know what size I need to order? Truck is not even here because it is at the body shop getting a tab repaired on the cladding that the mechanic broke. No mechanic jokes please! It is still a touchy...

Re: Installed Autometer Water temp gauge...now check engine light??? Thanks all! Problem sorted. He put the original sending unit in its original place, and hooked the dash gauge back up. Then found a port to use for the aftermarket gauge. thanks again!

Re: Installed Autometer Water temp gauge...now check engine light??? OK I just checked with him....there isn't a port on the water pump. So....leave the original setup intact (factory sensor and dash water temp gauge) and seek out another port for the aftermarket sensor. Not on the water...

CEL came on after installing aftermarket gauges (water temp, oil press., boost). Code 15 Coolant temp sensor. I have a gentleman doing the work for me and he used the new water temp sensor/sending unit in the original one's location and hooked it up and left the original dash gauge unhooked...

Re: Center Cap Lock Thank You!

Re: Center Cap Lock https://web.mail.comcast.net/service/home/~/?auth=co&loc=en_US&id=474737&part=1

Looking for a center cap wheel lock. If you have one laying around I sure could use one. You can text/call me directly at (217)454-2484. Thanks, John

Re: Turbo Tweaks Velosyty Thank you. Is an injector upgrade necessary or are the factory 30s adequate to get me to 17-18 Lbs.?

Re: Turbo Tweaks Velosyty So....with say a 3 bar MAP, a 255LPH fuel pump, and an AFPR, how much boost could I safely run with the velosyty chip on 93 octane? And I know it varies greatly from setup to setup, but how much HP is an added pound of boost on a basically stock truck?

Is there any noticeable performance benefit to using Eric's chip on a stock motor? I'm wanting to keep the truck stock if possible, but am wanting a little extra performance. I'm not 100% opposed to larger injectors, AFPR,etc. if the boost needs turned up a few lbs.. Thanks

Re: Broken D/S motor mount... Trying a cherry picker first..wish me luck and thanks for the prompt suggestions.

I have a broken drivers side motor mount....what needs removed to replace it?? Or maybe a special tool to help....Thanks!

Hi, I saw a recent post saying you had new console cover hinges for sale. If so what is the cost and what are payment methods? Thanks, John

Re: WTB factory air intake PM me a pic of it if you would. Thanks