Search results

yup, that's what I got for it.

Beautiful Typhoon (located in Tacoma, WA). 99% rust free (some surface rust on frame, suspension components). Spent all of its life in TX, then SoCal, then recently up here in Tacoma, WA garaged of course. Slightly lowered w/a torsion bar crank on the front, Belltech leafs in the back (kept...

actually a better fix is to run a machine screw w/a lock nut on it and tighten it down as much as you can while still being able to somewhat smoothly operate the lever for the HVAC position.

I suggest anyone else having this issue of hissing out of that vacuum thing to take it off, spray some that will swell the rubber (I guess any petroleum product), clean it up, and try it out.

OK, I think I fixed it. the vacuum thing splits easily in half. nothing holding it together until it's mounted on the panel. after removing it and splitting it apart, I noticed one half is a labyrinth of raised rubber in a particular pattern. (wish I took a picture). After trying a trick...

another angle of the part

part number 16047875 is nowhere to be had.

I had two disconnected hoses in the engine compartment. still didn't help the vent issue after connecting them. took apart the controls. stuck my thumb on the square hole on the back of that thing where all the hoses connect to it. NOW WE GOT VENT AIR! Hissing in that area led me to...

WOndering if it's #9 here:

Anything in the engine compartment I can check before i tear apart my dash/heater box?

Looks like this is the ticket...

The high side port adapter doesn't fit and I can't anywhere on the internet that fits it. The blue/low side, I pulled the scrader valve out of the old hole and put on the adapter just fine. But this red/high side adapter...too big and I don't see a scrader valve in the old hole. ???

I guess the hot ticket is to buy these and put in a coupler in between: AutoZone part numbers. pn E87866 pn E87859

impossible to find? heater hose that is. can I just use regular non-molded hose?

I.e. something like this?

Do I need shorter bump stops? As you can see, I'm not that low at all. Brand new bump stops btw.

I went to lower the front of the truck some. Right side lowered just fine. Driver's side...lowered maybe an inch, but I keep loosening the bolt more and more until the key bolt head is almost an inch lower than the passenger's side bolt, yet the driver's side is still higher than the...

Came out of my Hummer, but will fit great in a Sy/Ty: Comes with mounting brackets/faceplate (behind the big screen) for an H3 (not sure if it'll fit an H2). Here it is on Amazon: http://tinyurl.com/yasbr4aj Works great! Nothing wrong with it! Would help to buy this adapter for it...

Yup, sold it.

Talking about the FRONT driveshaft; not the rear one.