Recent content by Aeroking

Facebook killed the internet. Simple answer.

why do you need a work around? You just copy the picture address, and do a Instead of using another service.

Re: Idle/drive transition and bogging with the TC locked Without looking at your datalog, i can make some unprofessional assumptions. If the truck is bucking under acceleration, i would guess that you are locking the converter too soon. The trans will let the converter lock in 2nd, 3rd...

Re: Timing Questions Yes, its a 14mm spark plug thread. And don't bump the starter with the tool in the engine, it'll break off inside the engine, and you'll be screwed. Turn it by hand.

Re: Timing Questions First, leave the tan wire plugged in for the first few steps (it helps the engine start up) Locate TDC on #1 cylinder (driverside front closest to alternator) You can use any type of TDC tool. Once you have the engine rotate to TDC #1, look at the balancer. If you're...

Re: Magnafuel pump I would worry. It's definitely going to be strenuous on the pump. Pumps are great at making pressure on the discharge, but they suck at sucking on the inlet. Why did you put the pump so high?

Re: Oddfire compatibility? EFI connection 2500, so I can do 6 injector and 6 ignition sequential

Re: Oddfire compatibility? EFI connection a quick screenshot of the setup page

Re: Oddfire compatibility? EFI connection I have EFI connection stuff on my truck with the Haltech Elite. I use 6 LS3 coil packs, it works fine. And for oddfire, you can just identify which cylinders are 120, and which are 90, you dont need a oddfire distributor. I have the billet front...

Re: New Syclone 1/8 mi PB 6.84 @ 104 Nice run. Keep it up.

Re: Syclone #136 I started the truck for the first time in 9 months last night. Everything worked great, no crossed wires, no fuel leaks. I have a few evenings left to get it cleaned for Carlisle. Unfortunately i dont think i have time to cut and weld on the muffler, or to sand and paint the...

Re: Tuning Help Please are you looking for tuning advice? or are you looking for someone to tune it for you?

Re: Syclone #136 It's just tubing with tube nuts. Nothing exotic.

Re: Syclone #136 Today is the 10 year anniversary of my truck’s build thread. So I’d like to give an update of change I’ve made recently. I’m tying up some loose ends and cleaning it up for Carlisle. I’ve had a lot of new parts sitting in boxes from years past, and I’ve tried to put...

Re: Typhoon 2.0 New PB 10.49 @ 129 Nice runs. Congrats. I sealed off my air filter from the enginebay, and noticed a drop in my IATs. Not huge, but noticeable.