ls1 kenne bell project finally making progress

[Dmc12]

thats awesome!

[vettandtyphoon]

Updates. Pics toniggt

I had the trans beefed up and swapped the output shaft to the trailblazer ss one.
Transfercase trans converter custom 3" driveshaft and front shaft all hooked up
Had to modify a few things on block using oil galleys for remote oil filter setup as rpm pan doeant have any fittings

Motor going back in truck today
Doors tailights fuel system guages are all wired dash speakers and stereo all back in truck

Need wire neutral safety switch for trans and center console will go back in

[vettandtyphoon]

this was my little helper for most of this

pics below are not best quality a few of engine and underside. entire drivetrain is in the truck and bolted down. need to wire the transmission neutral safety switch. and interior will be pretty much be ready to go back together.

need to fab a set of headers so i can run the wires to the starter without having to worry about melting shit.

computer is in the passenger floorboard engine pretty much all wired up

need to get headers done and put the core support back on to start fitting the radiator and fan setup

[killa66cam]

Looking great...can't wait to see the finished product!!! I saw this: http://www.pasmag.com/features/rides...lac-cs-v-coupe ,the other day at Wally-World, and thought about this thread. I hope that I have something with an LS motor and a KB SC on it one day too!

Cam

[vettandtyphoon]

Updates my friends. Sorry I've been busy at work
Motor is in and wired
Fuel system is in and wired
Small f body mini starter in
All accessories bolted on motor waiting on a corvette ac bracket so I can mount pulley for belt routing
Found headers that clear. Sanderson ls1 4x4 s10 headers remember I am using a low profile steering shaft
Pics to come

[vettandtyphoon]

[vettandtyphoon]

[vettandtyphoon]

[vettandtyphoon]

[Syclone22]

Looking good this will be a torque monster just
keep updating how much boost will you be running ??

[vettandtyphoon]

Originally Posted by Syclone22

Looking good this will be a torque monster just
keep updating how much boost will you be running ??

I will start at under 10 lbs for now. I will start building another motor for more boost. Just want to get her going

[Syclone22]

Originally Posted by vettandtyphoon

I will start at under 10 lbs for now. I will start building another motor for more boost. Just want to get her going

Nice 10 lbs will still give some seat of the pants kick
i had a Colorado LS1 engine swap with Kenne bell
supercharger running 8 lbs fryed the tires instantly ..
b.t.w love the twin radiator fans set up for clearance ..

[vettandtyphoon]

Originally Posted by Syclone22

Nice 10 lbs will still give some seat of the pants kick
i had a Colorado LS1 engine swap with Kenne bell
supercharger running 8 lbs fryed the tires instantly ..
b.t.w love the twin radiator fans set up for clearance ..

Its good to hear lol. I'm Hoping it will move a lil bit. I really hope its faster than my v6 was. That went 11.7

[Smkur50]

Did you order the sandersons from their website, can't seem to find them..how much were they?

[vettandtyphoon]

Originally Posted by Smkur50

Did you order the sandersons from their website, can't seem to find them..how much were they?

I called them 450$ coated. Needed to modify steering shaft