I went out to start the ty and when I turned the key from on to the start position all power to the truck was lost and hasn't come back. I started at the Batt which was good at 13.4 volts, then on to the back of the alternator which only had 1.95 volts. Pulled all the wires off the alternator post and power on the battery to alternator lead came back up to 13.4v. Traced the low voltage to the bulkhead connector on the firewall and I cut the 2 combined red wires that are the farthest back then voltage was good from the alternator to the bulhead connector but if I hooked up the other red wire again (that runs from the bulkhead connector into a wiring loom directly below) then voltage dropped back to 1.95. voltage drops from 1.95 to 0 if I open ther door, turn on headlights, depress brake pedal or turn ignition key to the on position. All fuses are good, so are the 2 fusible links and the 10 amp wetherpack fuse off the back of the alternator. If I only hook up fusible link S100 from the alaternator to bulkhead connector voltage is 4.2, if I connect the other fusible link then voltage drops to 1.9. I also disconnected the wires from the starter with no change from the 1.95 volts. Where could this short be, engine bay, ignition switch? any troubleshooting tips would be appreciated.