Recent content by bjk_typhoon

Re: ...knock...knock! Enough room to get a tourque wrench up inside to retighten them back up again comfortably?

Re: ...knock...knock! Anyone know how much effort / time it is to remove the Flywheel / Flexplate while the engine is still in place? Or is it just easier / better to remove the engine to acomplish it correctly?

Re: Edelbrock Aluminum Valve Covers Are those valve covers a two piece design or are the bolts around the out side just decoration?

Re: Place your bid for the Last 93 Typhoon & WIN PRIZES!!!! $31,500.00

Re: Check out this Cold Air Intake If you hold your ass cheeks up to it and fart is that worth at least 1 psi of boost?

Re: Time to move on....... " Funny thing is that I had it inspected (annual PA insp) recently by a local guy that works on a few Typhoons and he mentioned how quick this Sy was compared to the Tys he works on." I am just north of Allentown Pa and drive to Jersey everyday for work. I am looking...

Re: Thread sizes of rear plug(s) (Back of motor) See I knew that there was a wise weenie out there. Both a tapered plug would explain my major oil leak. Stupid engine builder he kramed in a straight thread, way to go idiot. Thank you for the valuable infromation. -BJK

Re: Thread sizes of rear plug(s) (Back of motor) There has to be a baineack / goorue out there somewhere that knows anyone?

Re: Thread sizes of rear plug(s) (Back of motor) bump

Does anyone know the correct thread sizes of these two plugs?? I beieve the one on the left is a tapered plug??

Re: Valve cover spacers If you are only looking for a little bit more height just rtv two rubber gaskets together let them dry then bolt them in place. You will gain .060 to .080 with no leaks.

Re: Cool pic from in the Ty on the 405 Frwy I believe that picture is taken from the wrong angle. You should have been ahead of him, or did you back off so that you could fit the entire car in the shot.

Re: Need detailed pics of stock motor The missing bolt in my picture above is the one that the stud goes into to mount the clamp that goes around the fuel lin to keep it in place. Should be the one kind of above the knock sensor below the manifold bolt. -BJK_Typhoon

Re: ok, can we get a NY NJ CT list together? Brian Kolonia Live in Danielsville Pa (Close to Allentown PA) Work in Phillipsburg NJ

Re: Need detailed pics of stock motor Here is a back side shot. the bolts with star washers had the grounds.