Recent content by heavy breather

We've made 5 sets of motor mounts we need to send out for fitment testing and we're looking for testers. These are solid mounts designed to bolt onto the block and fit the factory frame pads. We know these fit the frame, and the block, what we're looking for now is clearance issues with...

Here's a tracking number for the four link. I am having issues with my phone and the tracking, but Jeff looked it up and it says it'll be delivered tomorrow. 1z440x73032867880. Mike

Re: Typhoon Bolt in 4 Link Success The c209 is too short in my opinion. Technically, it would bolt in, but by the time you preload the 12" spring a little the clearance between the cladding and tire would be dangerously tight. With 3 inches set between the tire and the cladding there is 17...

Re: Typhoon Bolt in 4 Link Success https://youtu.be/LJJ8DQEPa0g

Re: Typhoon Bolt in 4 Link Success I just ordered a set of warriors for Tyson with upgraded bearing ends, and 14 inch springs bill was $421 plus freight. Retail I've seen is 469-489 for their basic warrior with rubber bushings instead of the bearings. These are spec'd for these trucks in this...

Re: Typhoon Bolt in 4 Link Success First production kit is complete and will be installed Saturday pending arrival of the coil overs from Viking. We will post up pictures/instructions from the install after its complete. Also, we have decided to make Viking our shock of choice with the kits...

Re: Typhoon Bolt in 4 Link Success Stock has been ordered and we plan to install a kit in the next two weeks, which will provide install pictures and instructions. Once the instructions are finished, we'll begin shipping kits. I am trying to get a deal on shocks and springs to pass along with...

Re: Typhoon Bolt in 4 Link Success JSM typhoon kits are ready for orders, contact me in Private for details. Also, we have a syclone available for development of the sy specific kit and expect to announce a ready kit soon.

Re: plug question 6 heat range is recommended to @15 psi. I've run 5's 55's and 6's. I'm putting the br7's in tonight and going to tinker with the tune to see. Yes, the 7 is cold, but I think the safety of the electrode design is too beneficial not to give them a shot, especially when I only...

Re: plug question Just talked to ngk about this and have been looking into these plugs myself. What it boils down to is the plug will not self clean until 450°. Take out some fuel to warm the plugs at low load/rpm and add a couple degrees timing in those areas as well. That should be enough...

Re: How far are you willing to travel for a major SyTy Event? You'll always get the core group to show, trucks or not, and there will always be people that say they'll go, but don't. No matter how well it goes there will always be complaints. I say if you build it they will come. If not...

Re: Torsion Bar Delete Crossmember Sorry for the delay guys. USPS has been a real pain about these. They were all shipped at the actual post office and both locations recommended that I box the items this way, as they couldn't sell me a box that would work (long story.) I also did not pay...

Re: Torsion Bar Delete Crossmember As Jeff said the first five went this morning 9 am. Other than those headed to the Great White North all are scheduled for delivery Monday. Alright, here you go..... Signature Confirmation service numbers as follows: Ziembicki 2312 3170 0000 0299 2001...

Re: JSM Rides again.......... What's amazing is: in 13 odd years of these trips this is the first time there was no catastrophe involved. No hospital/no po po/ no vehicular carnage/ not even a single external challenge to DObreak's sexuality. Definitely a milestone, but somehow sad as well...

Re: Make up a story I'm going to help out, it Involved kegs and homless guys