Recent content by norbs

This is a ton of work to make connections to that board. These systems work great if you have the patience to tune them and have a good quality wideband controller. If you want cheaper use a microsquirt and solder in all the wires yourself for $450.

If you update it with the ms3 software it will be fine! I can help you with it if your stuck getting it going.

Good to hear I been tuning mine at -15c it was a rough start a few weeks back but I got it going finally. I am now build a new 3 bar map file for it. I still need to find the pin out for the ac as well to make that work. I have a support forum up that Motocam aslo helps with answers, might be...

HI Looking for the following parts: Inside heater core case right side Rear window shocks Rubber flaps inside wheel wells

Did you run the ground wire back to batttery?

Whats the size of that capacitor?

On My Gn the P.Ratio is about 1.5 thats with a 76mm compressor and 1.44 t4 AR side. Switching the ar to 1.01 the PR went to 2.2 about but the different in spool up time is about 1 second slower on the big housing.

Get the one that uses the bosch 4.9 lsu it s better design than the 4.2 lsu

I messaged a few vendors, but seems like they are not interested in responding seems odd to me.

Whats the biggest size turbo that would work well on the stock converter, direct fit bolt on. Some lag is ok but dont want it to be a dog either..Goal would be the biggest size wheels to fit in stock style housing.

I would be interested in the ecu if the new buyer wants to sell it..

Looking for fast XFI caspers adapter harness for plug in play install for sy/ty.

HI everyone, I have been in the Buick community for years, but now I am expanding fast help and tuning. Your Welcome to join my facebook group if you have any classic or xfi troublesor just want to know more about the system in detail. I can do remote tuning and troubleshooting fairly...