Recent content by samgm2

  1. S

    Fuel Shut off...

    Re: Fuel Shut off... That helps a LOT. I think you are right. It's a 3.1 Liter V6. Sam.
  2. S

    Fuel Shut off...

    I have a 749 installed into a supercharged chevy cavalier (Z24). I've been told that this is the computer to run for forced induction applications. Not sure why people think that because I can find very little in the way of documentation for use of this ECM in ANY OTHER Vehicle. In any case...
  3. S

    So there I was cruising along at 105mph turning 1675rpm when I realized....

    Re: So there I was cruising along at 105mph turning 1675rpm when I realized.... It's a very buggy program. Yes, fails to start logging most of the time. Fails to continue logging even when it does start and crashes after a bit of logging. Datamaster works well. Sam.
  4. S

    oil level sensor?

    Is there an oil level sensor on the typhoon or syclone? I am trying to get 7749 (58 code) to run in a supercharged cavalier (3.1 V6). The engine starts, then shuts down. The fuel pump is being shut off. I swapped the from MAP to MAP2 as the input on the ECM and the computer is getting map...
  5. S

    1227749 ECM into other vehicle.

    I am putting a 1227749 (58 code) into a 1990 Z24 cavalier. The engine starts and then dies because of fuel cut off. Is there an oil level sensor on the sy/ty? If so, what pin does it go to on the ecm? Should this be tied hi or low (assuming the above is correct)? Thanks, Sam
See more
Top