Recent content by turbo_tuna

Syclone has been sold. Long live #0014!

Re: 1991 Syclone for Sale: Responded to PMs. I hope everyone is having a great weekend. I should have pictures available this week.

Re: 1991 Syclone for Sale: Sir you are correct on both! I was not aware the truck was on this forum! If you have any more history feel free to post.

Hi all, I am looking to sell my 1991 Syclone. I have owned this Syclone since 2012. It was formerly part of the Lingenfelter collection. Vehicle has 57k miles on it. Not sure if there is any chip or ECU mods. Here are the recent services I have performed: 2016: 1. Turbo overhaul service...

Re: ABS help Thank you all for posting. I was able to clear the codes using the following procedure: To erase stored fault codes, a scan tool or the following manual procedure can be used. 1. Turn the ignition switch on. 2. Connect a jumper wire or key between diagnostic connector terminals...

Re: ABS help Just replaced the front sensors. How do I clear the ABS code. Right front sensor was bad.

Re: Random Stalling Update: I replaced the ICM and coil. Interestingly enough it now stalls when cold and less when hot. Seems like it inverted the problem. It also seems to idle weakly as if it's on the verge of stalling. Can anyone recommend a good data logger and what I need to be...

Re: Air Conditioning System repair Is R-12 even still available? I wonder if the cost of converting is a wash to the expense of r-12. My compressor and lines seem to be ok. There is a small amount of charge in the system and it is short-cycling. I suspect it is the original charge.

Re: ABS help Do I need a special puller to get the bearing hub off the spline?

Re: Abs/Brake lights but no codes Thanks!

Re: Random Stalling I was thinking of doing the same thing and just ordered the parts. I will post my results once I get everything in. Hopefully, I will have the same results. I appreciate your help.

Re: Random Stalling No I have not. Where is located next to the coil or under the cap like the HEI units?

Re: Abs/Brake lights but no codes What is the procedure to do this?

Re: ABS help Update: Pulled codes 21, 23, 26 and 28. Tested the right front sensor and no resistance. Driver side is around 14 ohms. Ordered new front sensors. Has anyone here replaced them. I am hoping I don't have to remove the bearing hub.

Re: No speedometer, ABS code 35, 37 Update. Issue was VSS. After I cleaned it up speedometer works great. Ordered and replaced VSS. Still chasing ABS issue.