Recent content by TheRock

Re: Jumped IC Pump = No Start HAHA no. I ran outside, checked the ECM 10A and it was blown. I replaced it and all is well. Thanks so much for the quick reply. :)

Okay, so I needed to get my IC pump going and I did some searches to find a solution that involves jumping the yellow wire on the pump relay on the firewall. Unfortunately, I misread and assumed I needed to put + to this, and this is where the trouble began. Note: putting +12v to the yellow...

You should add L35 to your searchable phrase list.

I recently purchased a Syclone and need the heads pulled for a head rebuild, and possible just pulling the engine for a complete rebuild. Time is ticking to get things running for summer, and it needs some work. Anyone up for helping for a few $$ in my garage or even taking project on...

Maybe something like this would do: http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&rd=1&item=7916339597&category=33595 I need one as well. Is this an easy install, or do I have to pull the column?

Get some line locks. You can use dinky brakes and just up the pressure with line locks. Go up to the line, let it idle for lots of vacuum, hold the line lock button, and pump those brakes! My omni has tiny brakes, and I can hold the car dead still on the line. Max boost is unknown, but I...

Where you guys buying your wide-band O2s?

Do the monomax work well with the drop from the BellTech springs? Anyone have part numbers for the BellTech springs?

My Syclone has 109,000 miles and it is time for suspension work. I'm thinking on the Monomax's from TireRack with the lowering leafs from Summit. Good combination? Any other recommendations that won't cost a fortune? Thanks, Rocky

Thanks for the info!

Anyone know what CFM the stock W2A IC flows?

Thanks for the reply, I certainly appreciate it. I'll register the PROM app and see how things go. I already had chips and a burner from editing the cal for my race Omni, so it seems easy to dig into the Syclone cal. Later, Rocky

Ok, I have a stack of blank 27C128s, a programmer, and an eraser (UV bed) and I'd like to tune the stock ECU. A few questions: 1.) What software am I supposed to use (for changing the maps)? 2.) Where do I get the software? 3.) Does someone have the stock BIN available for download? Thanks, Rocky