jeepruby04
New member
Re: 2nd Gen front brake swap with ABS
Just found this in the vault http://www.syty.net/forums/showthread.php?t=1532
Just found this in the vault http://www.syty.net/forums/showthread.php?t=1532
2nd Gen front brake swap with ABS
- Thread starter jeepruby04
- Start date
Turbotoyz
Member
aasltmike
Active member
Re: 2nd Gen front brake swap with ABS
Couldn't post anything in the vault on that link, but I have a question about this upgrade to dual piston calipers. I went to the salvage yard earlier today and got the steering knuckles, dust shields, and caliper brackets out of a 1999 Blazer 4x4. The holes in the knuckles that the axle shaft goes through are bigger than the stock knuckles on my Ty. I know that you have to use the wheel bearing assembly from the 1999 Blazer to match the knuckle, but how does it mate with the CV axle on my Ty if the hole is bigger? I'm guessing that I just need to replace the grease seal on the knuckle and route the axle shaft end into the knuckle and hub assembly. Is this the case?
Couldn't post anything in the vault on that link, but I have a question about this upgrade to dual piston calipers. I went to the salvage yard earlier today and got the steering knuckles, dust shields, and caliper brackets out of a 1999 Blazer 4x4. The holes in the knuckles that the axle shaft goes through are bigger than the stock knuckles on my Ty. I know that you have to use the wheel bearing assembly from the 1999 Blazer to match the knuckle, but how does it mate with the CV axle on my Ty if the hole is bigger? I'm guessing that I just need to replace the grease seal on the knuckle and route the axle shaft end into the knuckle and hub assembly. Is this the case?
jeepruby04
New member
Re: 2nd Gen front brake swap with ABS
Apparently the newer bearings don't need a dust shield.
This is the 2000 s10.
This is the Sy.
Sorry the pics. suck.
Apparently the newer bearings don't need a dust shield.
This is the 2000 s10.
This is the Sy.
Sorry the pics. suck.