Fitment question?

[Peter W.]

Can someone tell me if this setup will work: 20x8.5 in the front with a 20mm offset and 20x10 or 20x10.5, owner isn't sure, with a 30mm offset. The wheels were on a 2001 jaguar xk. The bolt patterns is 5x120. Owner mentioned that they would work for a corvette but the offsets I think maybe too low, but I am not 100% sure. What do u guys think, will this setup work? Any help would be great!!!

 

[Andreas]

Re: Fitment question?

Not the best fitment to start with...

27mm out on the fronts.
not to bad on the rears if its 10" wide rims, just 8mm out

punch in the numbers and calculate
http://www.sytyarchives.com/howto/viewarticle.php?article_name=wheel_tech.php&dir=exterior

don't forget to check the hub diameter.

 

[Peter W.]

Re: Fitment question?

Tried using the calculator but I don't know what I am doing. So do u think I should just pass on the wheels?

 

[Andreas]

Re: Fitment question?

Hard to say for sure without seing the wheels.
If it was "to much offset" spacers would solve the offset issue with the front wheels quite easily but machining down 20-27mm on the front rims to get a reasonable offset seems to be alot. May not even be possible with the wheel design.

 

[Trizney]

Re: Fitment question?

The wheels were on a 2001 jaguar xk. The bolt patterns is 5x120.

That is not the correct bolt pattern.

5x4.75 = 5x120.65

Close, but not correct.

 

[Andreas]

Re: Fitment question?

5x120 works just fine.