Heater doesnt work...

R

red-y2k-l

New member
Hey guys im not sure where i should post this so im going to post it here.
The problem is that my heater only blows out cold air. So i took of the piece where you control the air and i saw that this line was loose



What im wondering is where does this line go to?

Thanks,
-miguel
 
C

Crimson93Ty

PITA new guy
Re: Heater doesnt work...

I don't think it's supposed to be bent all to hell like that. See if you can get it smoothed out enough to where it will go in and out smoothly again. There is one of those "press on nuts" that is supposed to hold the "eye" of that wire to the lever that makes that rod go in and out.
 
dgoodhue

dgoodhue

BuSTeD 4.3
Re: Heater doesnt work...

It obviously is bent, the ring part is supose to fit on the pin just above the 1 in your photo (with a clip). The red part is supose click into the part the heat cable pass by in your picture. The is assembly is a tight fit when done right, so someone was probably impatient as start hacking away.
 
R

red-y2k-l

New member
Re: Heater doesnt work...

Thanks alot guys i will try to get it done tomorrow and hopefully it will work. I havent been driving my truck cause its to cold and without a heater its worse.
 
Ian Turgeon

Ian Turgeon

Cascading Inspiration
Re: Heater doesnt work...

looks like it yea... worse come to worse you can pop the rear of the glove box out and move the lever by hand. (left = cold I think)
 
R

red-y2k-l

New member
Re: Heater doesnt work...

SyTyArchives said:
looks like it yea... worse come to worse you can pop the rear of the glove box out and move the lever by hand. (left = cold I think)
Click to expand...


Thanks!

-miguel
 
You must log in or register to reply here.
Top