Peter W.
New member
Ok so I have been doing some calculations for some new wheels for my typhoon. I need some serious help PLEASE. So the stock setup is as follows:
Front: 16 x 8 with 41mm offset
Rear: 16 x 8 with 13 mm offset
The rims I am thinking of purchasing:
Front: 20 x 8.5 with highest offset being 40mm, this would cause the wheel to be in 5mm and stick out 7mm
Rear: 20 x 10 with an offset of 38 causing the wheel to be 50mm in more than stock and stick out the same as factory.
I really don't think the 7mm sticking out is going to be a big deal, but what about the rear going in 50mm, is it possible. If I can get this wheels as close as to flush with the fender the better. What do you guys think, besides the fact that the 20" wheels are going to look to big on there, :rotf:
Any information would be great!!!!
Front: 16 x 8 with 41mm offset
Rear: 16 x 8 with 13 mm offset
The rims I am thinking of purchasing:
Front: 20 x 8.5 with highest offset being 40mm, this would cause the wheel to be in 5mm and stick out 7mm
Rear: 20 x 10 with an offset of 38 causing the wheel to be 50mm in more than stock and stick out the same as factory.
I really don't think the 7mm sticking out is going to be a big deal, but what about the rear going in 50mm, is it possible. If I can get this wheels as close as to flush with the fender the better. What do you guys think, besides the fact that the 20" wheels are going to look to big on there, :rotf:
Any information would be great!!!!
