Lowering the front of a TY

[TurboJunk]

we'll as you all know i just bought my first TY this past weekend and it hasnt been a week and ive already started ripping it apart.
ive lowered the back with 2in angled blocks and im lowering the front by turning the bolt for the torison bars. my question is how much did you turn your bolt out to get the truck down in the front?

 

[wrx2typhoon]

Re: Lowering the front of a TY

Right or wrong i cranked on mine til it didnt really lower anymore then went back in 2 turns.

 

[Junior1]

Re: Lowering the front of a TY

Its going to vary, some people say 2-4 turns equal an inch, but your best bet is to use a tape measure. Park on level ground (important) and measure the top of the tire to the bottom of the cladding. Also make sure you bounce up and down on each side to help them settle in so you get accurate measurements

 

[Joey Allen]

Re: Lowering the front of a TY

Since you've done the rear. If you have a local tire/alignment shop that you do business with. Take it to them and tell them what you want to do... let them put it onto the alignment rack and crank you bars down to where to want bounce it, align it and boom your done.