Syclone#892
Member
Well I think its time to sell the So Gt 
Plans are changing and I am looking at getting a different dd.
Truck currently has 152k on it
This truck has had a lot of work done to it to get it to where its at right now. When I got this thing it was horrible and didn’t run.
Here is a list of things I have done to it
Rebuilt trans at 132k
Installed reman engine at 140k
Trans has derale trans pan
Replaced rear diff with a used/rebuilt one, was suppose to be 3.42 posi but its 3.08 posi. I didn’t mind since it gets great mileage and cruises nicely down the freeway J
Installed belltech front sway bar, zq8 rear sway bar
Replaced all brakes, rotors, calipers, wheel bearings, drums shoes etc at 132k
Replaced all front susp components, control arm bushings, new moog coil springs, ball joints, tie rods, idler pitman arms zq8 gearbox at 132k
It even has Marty’s so gt’s original control arms on it
Replaced oil cooler lines with engine
Replaced spider injector and lines at 132k
Installed extrude honed intake with engine(thanks Marty)
Msd wires, ngk plugs
Installed programmable drac from Michael Hood
Installed magnaflow bolt in cat converter at 132k
Installed Gibson stainless exhaust at 132k
Installed walbro fuel pump from auto performance engineering at 132k
Installed new headliner from LMC truck, installed dynomat extreme on floor and back and put it anywhere something rested on to keep squeaks to a minimum. Installed new acc carpet, new heater core, did all that in the last month.
Installed auto dim rearview mirror with compass and temp, installed temp sensor behind front bumper
Has an original painted black/grey grille from Marty with black gmc letter
Installed autometer 3 gauge pillar with sport comp mechanical oil and water gauges and volt gauge
It has a sony xplod deck MEX-BT5100, 10” Rockford fosgate in small Rockford boxes, Rockford fosgate 800a-1 amp for the subs and 2 small older ppi amps for the front and rear speakers, front speakers are boston plates, rears are pioneer 4x10’s
Wired the entire stereo with tsunami wire, fancy tsunami fuse block under hood
Truck had 2” drop spindles and 2” blocks when I bought it.
Truck also has billet specialties 16x7 or 8 rims with 225/50/16 Bridgestone g009 with 9/32nds tread and 245/50/16 kuhmo ecsta 711 with 6/32nds tread
Truck comes with stock rear diff that has a bad pinion bearing, possibly more
Truck comes with solid back glass also
Truck does not come with cowl hood, that’s the syclones
It currently has a hinged soft tonneau cover from tekstyle on it, I have thought it over and I am going to take that off and install the hard tonneau cover that is currently on the sy and keep the soft cover. The hard cover came from a local store and only said Lakeland on it
Truck comes with all cladding and front bumper support, only pieces I am missing are the mounting brackets for the rear corners
Truck also comes with stock 14” s-10 steel rims with 205/70/14 ws-50 bridgestone blizzaks with 9 and 10/32nds
I also have new stainless flex brake lines for it that are not installed
The bad stuff now
The parking brake doesn’t work, it is missing the release handle, and a cable that connects the one line to 2 lines.
There is rust on the truck as seen in the pics, the worst spot is the driver cab corner which has a hole in it, I have a patch panel that I just haven’t had time to install
The dash is broken under the glove box by one of the former owners
Truck is dirty
It does have a small trans leak that I think is coming from the rear 4 bolt 2wd adaptor
The a/c does not work. It had no Freon when I got it so I don’t know if it has a leak or what, I have the compressor for it I just removed it and put the bypass pulley on when I was searching for a noise and never reinstalled it
The windshield does have a crack in it on the pass side, I will be having the windshield replaced soon so that will not be a problem for the buyer just figured I would mention it since its visible in some pics.
I am sure I am missing some good and some bad stuff but that’s all I can think of right now
I am asking $4000 which I see as a far price considering all the cladding cost over $1200 to get along with all the new/ recently replaced parts.
If I don’t get much interest I will keep it but probably sell off the cladding so I have some $ for my new dd.
Thanks for looking and email me with any questions as I don’t get on the board much to reply to pm’s
Edit: Duh here is the link to the pics http://rides.webshots.com/album/575062924dmxeZU
Plans are changing and I am looking at getting a different dd.Truck currently has 152k on it
This truck has had a lot of work done to it to get it to where its at right now. When I got this thing it was horrible and didn’t run.
Here is a list of things I have done to it
Rebuilt trans at 132k
Installed reman engine at 140k
Trans has derale trans pan
Replaced rear diff with a used/rebuilt one, was suppose to be 3.42 posi but its 3.08 posi. I didn’t mind since it gets great mileage and cruises nicely down the freeway J
Installed belltech front sway bar, zq8 rear sway bar
Replaced all brakes, rotors, calipers, wheel bearings, drums shoes etc at 132k
Replaced all front susp components, control arm bushings, new moog coil springs, ball joints, tie rods, idler pitman arms zq8 gearbox at 132k
It even has Marty’s so gt’s original control arms on it
Replaced oil cooler lines with engine
Replaced spider injector and lines at 132k
Installed extrude honed intake with engine(thanks Marty
)Msd wires, ngk plugs
Installed programmable drac from Michael Hood
Installed magnaflow bolt in cat converter at 132k
Installed Gibson stainless exhaust at 132k
Installed walbro fuel pump from auto performance engineering at 132k
Installed new headliner from LMC truck, installed dynomat extreme on floor and back and put it anywhere something rested on to keep squeaks to a minimum. Installed new acc carpet, new heater core, did all that in the last month.
Installed auto dim rearview mirror with compass and temp, installed temp sensor behind front bumper
Has an original painted black/grey grille from Marty
with black gmc letterInstalled autometer 3 gauge pillar with sport comp mechanical oil and water gauges and volt gauge
It has a sony xplod deck MEX-BT5100, 10” Rockford fosgate in small Rockford boxes, Rockford fosgate 800a-1 amp for the subs and 2 small older ppi amps for the front and rear speakers, front speakers are boston plates, rears are pioneer 4x10’s
Wired the entire stereo with tsunami wire, fancy tsunami fuse block under hood
Truck had 2” drop spindles and 2” blocks when I bought it.
Truck also has billet specialties 16x7 or 8 rims with 225/50/16 Bridgestone g009 with 9/32nds tread and 245/50/16 kuhmo ecsta 711 with 6/32nds tread
Truck comes with stock rear diff that has a bad pinion bearing, possibly more
Truck comes with solid back glass also
Truck does not come with cowl hood, that’s the syclones
It currently has a hinged soft tonneau cover from tekstyle on it, I have thought it over and I am going to take that off and install the hard tonneau cover that is currently on the sy and keep the soft cover. The hard cover came from a local store and only said Lakeland on it
Truck comes with all cladding and front bumper support, only pieces I am missing are the mounting brackets for the rear corners
Truck also comes with stock 14” s-10 steel rims with 205/70/14 ws-50 bridgestone blizzaks with 9 and 10/32nds
I also have new stainless flex brake lines for it that are not installed
The bad stuff now
The parking brake doesn’t work, it is missing the release handle, and a cable that connects the one line to 2 lines.
There is rust on the truck as seen in the pics, the worst spot is the driver cab corner which has a hole in it, I have a patch panel that I just haven’t had time to install
The dash is broken under the glove box by one of the former owners
Truck is dirty
It does have a small trans leak that I think is coming from the rear 4 bolt 2wd adaptor
The a/c does not work. It had no Freon when I got it so I don’t know if it has a leak or what, I have the compressor for it I just removed it and put the bypass pulley on when I was searching for a noise and never reinstalled it
The windshield does have a crack in it on the pass side, I will be having the windshield replaced soon so that will not be a problem for the buyer just figured I would mention it since its visible in some pics.
I am sure I am missing some good and some bad stuff but that’s all I can think of right now
I am asking $4000 which I see as a far price considering all the cladding cost over $1200 to get along with all the new/ recently replaced parts.
If I don’t get much interest I will keep it but probably sell off the cladding so I have some $ for my new dd.
Thanks for looking and email me with any questions as I don’t get on the board much to reply to pm’s
Edit: Duh here is the link to the pics
http://rides.webshots.com/album/575062924dmxeZU