Ty will not start

Osmosis

Osmosis

New member
I just rebuit and installed my new transmission. Now she will not start. She's been sitting inmy garage for a year and the last time I started her was 8 months ago. I finally get the transmission and transfer case all installed and now she will not start.

I checked for spark. I do have spark. No lighting but I so have spark. FP - 45 psi at start up.

The reason I put it in this fourm is that I remember the wire harness on the drivers side top. I did not connect any grounds to that bolt. Some of my previous cars did require some grounds to go in this spot. I did not hook up any grounds but I checked my ground on top and they are secured..to what...I Dont know?

?????:( HELP please.
 
SY2932

SY2932

Administrator
Re: Ty will not start

Having that ground off certainly won't do you any favors in the long run. As much as a PITA it is to reconnect, I would do that first and see it that fixes your problem. But if it doesn't...

IMG_1831.sized.jpg

"If the chip is installed correctly, and you definitely have both spark and fuel pressure, your ignition module is dead. A bad ignition module won't generate a reference pulse preventing the injectors from firing. Part number is 1048-2827 (located under your distributor cap, BTW). Some auto chain stores can test to confirm it it's good or bad."

I fought this problem in my truck after it sat transmissionless for 2.5 years. I was able to start it after I got the transmission back in and it ran for about 5 seconds before it died and wouldn't restart. A new ignition module got me back on the road again in my case.
 
You must log in or register to reply here.
Top