92Typhoon1679
Member
I have a Nice piece of drivers side rear corner cladding forsale it has a couple of SMALL repairs on the inside corner but NO broken tabs just two mounting holes repaired where the rivets go the repairs are from when people hit it in a parking lot so they are small. I sprayed it with a light coat of filler primer just to fill in rock chips and light scratches in the paint but ive spent hours wet sanded them out with 600 grit so its SMOOTH i wet sanded the cladding down to the paint so its not covered in primer is only primer in the small sratched and stuff and its ready for primer and paint. Im still doing a little finishing on it but it will be done this weekend
Today Friday i finished up wet sanding and put a VERY light coat of Black primer just to protect the surface and take pics this piece is actually very nice and ready to paint.. I have several drivers side pieces and this one is probably the nices used piece ive seen next to new because its not warped or dryed out making the plastic brittle
I perfer a trade over money but i just have Too many of these drivers side pieces I need passanger side pieces Or a Chip
I want $300.00 plus shipping or trade for a Passanger side rear corner cladding or a used Ultimate chip for the vortec heads 50lb injector 412 cam setup.
You can contact me VIA
Email rosszahara@hotmail.com
Ross Zahara
Tele 1-360-598-0777
Pics are available upon request
I dont check my Email Every Hour so it might take time for me to respond
Today Friday i finished up wet sanding and put a VERY light coat of Black primer just to protect the surface and take pics this piece is actually very nice and ready to paint.. I have several drivers side pieces and this one is probably the nices used piece ive seen next to new because its not warped or dryed out making the plastic brittle
I perfer a trade over money but i just have Too many of these drivers side pieces I need passanger side pieces Or a Chip
I want $300.00 plus shipping or trade for a Passanger side rear corner cladding or a used Ultimate chip for the vortec heads 50lb injector 412 cam setup.
You can contact me VIA
Email rosszahara@hotmail.com
Ross Zahara
Tele 1-360-598-0777
Pics are available upon request
I dont check my Email Every Hour so it might take time for me to respond
Last edited:
