Good morning all, and merry Christmas,
I am putting the top end together, with vortec heads, and trying to figure out if I need to machine down the heads for the guide plates. -the platform of the studs,-the thickness of the guide plates
using 1.52 full roller
I would also love to use the factory vortec valve covers, but im not holding my breathe.
thank you for any advice
Matt
I am putting the top end together, with vortec heads, and trying to figure out if I need to machine down the heads for the guide plates. -the platform of the studs,-the thickness of the guide plates
using 1.52 full roller
I would also love to use the factory vortec valve covers, but im not holding my breathe.
thank you for any advice
Matt