Recent content by ndburli

Re: Decelaration Surging I currently have it plumbed coming off the intake to brake booster line. I also used teflow tape...should I used something else to ensure no leaks?

Re: Decelaration Surging Yes. My plan is to disconnect and check. The way it gulps for air and stops when I push the brake males me think it is something I did with the gauge install off the booster line

Re: Decelaration Surging Thanks for your response. I am certainly at a loss. I will try checking the vacuum and brown wire

Re: Decelaration Surging Do the symptoms Im describing sound like a vacuum leak even though idle is perfect and I have no issues with drivability outside of the minor deceleration surge? I guess if it is gulping ait it must be some type of Vac leak

***UPDATE*** Still looking for some help HOWEVER I did a little further diagnostic today. The truck does in fact surge when I let out of the gas (whether in boost or not). It usually happens around 30-35mph however can happen anytime I let off the gas in that range. It surges/gulps between...

Re: Tiny paint flaws=tiny crows feet? I have also noticed these on my Sy as well. I used 1000, 1500, and 2000 and sanded with water. I then buffed out with compound and mirror glaze (3M). It helped it. There is really nothing that will remove them completely except to sand and re-paint...

Re: Timing Questions Thanks so much! You were a huge help.

Re: Timing Questions Is the TDC tool for 14mm? What size spark plug do our trucks have?

I have reviewed a lot of the previous posts on the forum. I have a few timing questions. Unplug the tan wire to set the timing Locate TDC with a TDC spark plug tool (I would assume once I find TDC I would install the plug back into place correct? Which spark plug is #1 --looking at the front...

Re: Tick Tick Tick (Injector Noise) Thanks so much! This is what I need.

Hey guys, I have done a lot of research on the forum and came across a post from several years ago. http://www.sportmachines.com/wiki/ti...hp?galleryId=2 (Apparently this at one time was a remedy for injector tick noise) Needless to say the link is no longer active. Is there an actual fix...

Re: Another cladding repaor thread Thanks for the posts. I am in the body shop business/insurance business so I may have one of my local shops Nitrogen weld the cladding for me. If that doesn't work I will get some of the 3M Rigid parts repair. My concern is certainly not the repair holding...

Re: Purchased Another Sy-Tune-Up Questions Thanks for the feedback gents. The truck is being shipped and I should have it by weeks end. I will be starting the maintenance next week as I am off work. I found out the wires, cap/rotor, plugs were all changed within the past 2000 miles. I will...

I've read numerous things. I am going to be repairing a cladding that is original. I was going to use panel bond but also need to know what color it is. What color has everyone had success with on the original cladding?

Question...I will be completing a tune up on a SY I just purchased. This is a stock truck except for a few minor upgrades (HD propshaft, Larger intercooler pump, and Fuel pump). My plan is to leave the truck as stock as possible but certainly want to make modifications to areas that were...