Plastic fuel line alternative

motorhead

New member
napa sells replacement fuel line that resembles what is used on alot of newer cars.they have the 2 size o-ring style fittings that can be threaded into the pump and fuel rail, pressure side and return and the plastic line slides over the nipples and comes with crimp style clamps. easy as hell to work with and can be routed easy over the tight clearance bell housing area.

They worked great! after I had My engine and 4l80 in. I made and routed the lines back to the 2 rubber flex hoses by the t-case in about 15 minutes,no leaks and will never rust.

this will help you guys that have fought those old steel lines either over the trans or rusted to the fuel filter or fuel sender.
 

BigBadSmoosh

Picking fights on I-65 since 2013
Re: Plastic fuel line alternative

good to know, eventually i'd like to replace all the fuel lines in the syclone..
 

Loeryder

New member
Re: Plastic fuel line alternative

Something about using plastic anywhere there is high heat or chance of abrasion/crushing that makes me think SS braided lines might be a tad safer.
With nearly 100 PSI pumping through them at full boost I want some insurance.

Sounds like it was easy though and theres a price to be paid for easy. ;)
 

BigBadSmoosh

Picking fights on I-65 since 2013
Re: Plastic fuel line alternative

Loeryder said:
Something about using plastic anywhere there is high heat or chance of abrasion/crushing that makes me think SS braided lines might be a tad safer.
With nearly 100 PSI pumping through them at full boost I want some insurance.

Sounds like it was easy though and theres a price to be paid for easy. ;)

stainless can get expensive quick
 

motorhead

New member
Re: Plastic fuel line alternative

never seen a problem with them on all the cars I see using them from the factory,some are routed pretty close to manifolds and such.f-bodys and vettes,etc I dont know what pressure they are rated at but I would guess around 200psi not sure if there are many sy/tys running the fuel pressure you are man, yikes!
 

sytyguy

Moderated User
Re: Plastic fuel line alternative

motorhead said:
never seen a problem with them on all the cars I see using them from the factory,some are routed pretty close to manifolds and such.f-bodys and vettes,etc I dont know what pressure they are rated at but I would guess around 200psi not sure if there are many sy/tys running the fuel pressure you are man, yikes!

True, but most cars/trucks don't have rising rate FPRs like we do. So, while an LS1 might have fp set @ 58 psi or so, it won't get any higher. Our base can be 50 psi and with 25 psi of boost, the fp would now be 75 psi. I still don't think it's a problem for the plastic lines to handle, but just wanted to show that we can approach 100 psi with the right base and boost.

The pressure won't hurt the lines, and as long as the plastic stays more than 3-4" from heat, it should last a long time. I personally hand bent all my own line from 3/8" copper. It's easy to bend, will last, and is cheap (about $0.75 per foot). You can even use a 3/8 compression fitting to join the OE line to the copper if you're hesitant about flaring and using an AN adapter for the filter/rail/regulator.

Hood
 

vortecfiero

New member
Re: Plastic fuel line alternative

I buy the fuel lines with the correct GM fittings on them and bend to fit
in this pic you can see the vac lines made from brake lines

10015911mu.jpg
 
Top