Re: 19" 2009 Zr1's
P285/30R-19 and P345/25R-19 would work good. That 10" front might be an issue, most run a 56mm front with a 9.5" width and have to trim a little on the control arm, so your gonna want to like a 50mm (my best guess sine this isn't a common setup) at the most any more and it will probably be too far inside.
50mm offset will have the same amount of wheel on the inside as the common 9.5" with a 56mm offset.
With that 12" rear you can get away with quite a bit since it doesn't turn, again I would estimate a 40mm offset.
I'd message Ashman about the offset he used, IIRC he has 12" rear wheels.
http://www.syty.net/forums/showthread.php?t=47346&page=5
HTH