Alarm LED ideas?

Loeryder

New member
looking for some new ideas on LED placement for alarms.

I was thinking about the varads but those are old school nowadays.

Like the look of using the LED without the huge "slipcover".
Just takes a tiny hole too. those are gooder.

My idea is to use just the tiny LED in each speaker cover so they are VISIBLE.

whatcha think?
 

ed hess

race or get outta the way
I have 3 of em.
1 on each door interior panel in the front raised area near the mirror.
and one above the light switch in the knock outs.
ed
 

rdtyphoon

New member
LED Locations

LED Locations

You can mount them just about anywhere you can think of. i have installed them in door handles, speaker grills, door panels, rearview mirrors, anywhere. Just put them where you think they will look good.
If you get multiple LED's you can also buy pattern boards, this is a circuit board that will make the LED's flash in different patterns. DEI makes one.

Good Luck 0X
 

Ian Turgeon

Cascading Inspiration
i got one at each corner (rev lights, corner lights, and one in the dash) A switch to turn off the surrouding ones as well. That way I can make sure its armed from inside the house, and turn em off to keep from attracting attention when I dont want em to.
 

InvisiBill

Active member
I saw a demo Probe at a soundoff a few years ago. It had a scanner mounted on the back of the mirror, and the windshield was tinted. The LEDs appeared to just float there...

The LED with my alarm has a big clear plastic housing around it. It just happens to be the exact same size as the little vent holes along the top front edge of the dash. Looks pretty clean, and no drilling. I just slipped the wires between the dash piece and the ducting.
 
Top