Cut Bundled Wires??

TheObiJuan

Active member
does anyone know what these are for?
they look factory.
aaa.jpg

aab.jpg


this is a reserrected police typhoon.
these wires are coming from under or near the passenger side seat.
any ideas would be appreciated.

from what i was told thusfar, the only wires should be 3 wires bundled for the seat controls.
 

just a 6

R.I.P MyClone
Re: Cut Bundled Wires??

How about power windows and power locks on a 4-dr body? Maybe they were using the same harness as the 4-dr body?



TheObiJuan said:
does anyone know what these are for?
they look factory.
aaa.jpg

aab.jpg


this is a reserrected police typhoon.
these wires are coming from under or near the passenger side seat.
any ideas would be appreciated.

from what i was told thusfar, the only wires should be 3 wires bundled for the seat controls.
 

tx_t-type

New member
the top right (two pinks and two blacks) checked out for the cig lighter plugs..however, the larger bundle goes strait up behind the dash...where is the keyless entry module located? can the keyless entry be eliminated? my keyless entry went with the police radios that they pulled out...if i run a jumper wire from 12v to any of the two orange wires, it does the same as if the ignition was turned on....fuel pump and the few dash lights come on...
TIA
 

TurboTony

Active member
It's not a security system of any sort. It's just a remote keyless entry feature.

You could just go and find another module and connector and wire it back in. It's an awfully handy feature. Be aware that not all modules are created equal. There are three frequency ranges that they work on, you have to match the remote to the module. If you get a module from the boneyard take the donor vehicles VIN# so you can order the correct remote to match it.

One from a 4 door jimmy/blazer or bravada would be your best bet.

I was goin to install one in my sy, but I will get an alarm with a RKE feature instead.


Tony
 

tx_t-type

New member
thanks for the replies...
ok, one more stupid question...if the keyless entry bundle is cut, could that possibly keep the truck from generating spark? i did the MSD troubleshoot, and when i ground and unground the msd trigger wire, i get massive spark...but when i crank the engine, i get nothing...i just wanna make sure this thing runs before i continue assembly...ive checked the MSD connections and they check out fine as per the instructions that i downloaded from MSD....

thanks again

servando
 

tx_t-type

New member
got her running....dont know exactly what i did to finally start it, but it runs... :drinking: it runs smooth now at idle and rumbles my whole shop...apparently, my muffler was eliminated in its last life and it's a very deep sound...i finally got to check out the engine...never heard it run before...i checked the oil filler for blowby and found less than zero...im pretty sure thats good...lot more to go still...

THANKS FOR THE HELP!!! :infinity:
 
Top