FS: 4.3 BLK , Heads and Rotating assembly

[hrodgmc]

CPI block for bored .030
CPI cam with less than 1k miles purchased from TLcooper
Vortec heads w/ stock valves/springs reworked
GM crank .010/.010
Stock rods w/ arp bolts and Forged Speed pro's 4 .030 (they are 4v relief though ....Not greastest)
Hastings Ring set
ARP main bolts
ARP head bolts
Victor gasket set sy/ty specific w/ stk head gasket set
Melling stock volume oil pump with hardened shaft
New balancer
GM marine cast iron intake with FPR, rails, #30 ish injectors, IAC, and vertical T/B
Misc other small pieces from teardowns.

Machine work done by Mark Davis (Waller and Hood can vouch 4 him)
Mike Hinson did crank.

$2000 OBO. Make an offer. thanks for looking
Located in S. GA.
Buyer responsible for shipping charges.

 

[tlcooper]

Re: FS: 4.3 BLK , Heads and Rotating assembly

hey hrodgmc, I always wondered about the engine you were putting together after you purchased the cpi cam from me. I see you are going in a different direction, but good luck with the sales. For those who are buying, hrodgmc is a good guy. I've had business with him and he stand by his word. So whatever he's selling is an A one item. good luck again with the sales.

 

[hrodgmc]

Re: FS: 4.3 BLK , Heads and Rotating assembly

TLCOOPER, thanks man.

Stock Vortec heads with 20k miles. Have been resurfaced and 5 angle Serdi valve job with stock springs and valves. $200 obo...
Have pics upon request

4.3 Vortec Marine intake with injectors, rails, FPR, T/B, IAC are all new. $200 obo.

Both need to go so feel free to make an offer. Ended up usinig l35's.

 

[Injected1]

Re: FS: 4.3 BLK , Heads and Rotating assembly

TLCOOPER, thanks man.

Stock Vortec heads with 20k miles. Have been resurfaced and 5 angle Serdi valve job with stock springs and valves. $200 obo...
Have pics upon request

4.3 Vortec Marine intake with injectors, rails, FPR, T/B, IAC are all new. $200 obo.

Both need to go so feel free to make an offer. Ended up usinig l35's.

interested in Marine vortec intake, could you plz send pics to extreflections@aol.com. Does anyone run this intake with RPM billet fuel rails?

 

[hrodgmc]

Re: FS: 4.3 BLK , Heads and Rotating assembly

Selling for machine shop costs plus shipping if anyone needs anything.