FS: 750HP Syclone #434 in SF Bay Area

mrweelr

New member
With mixed feelings, I've decided to sell Syclone #434. I've owned the truck since 1999 and bought it from the original owner with ~35K miles. I paid $13500 for the truck and over the years invested $50K in mods into it. I have all receipts and this is an EASY 10-second truck. It had an RPM Street Terror motor and Prime Gears 4L80E trans installed in 2008 and has been driven less than 500 since that time. I took it to Infineon Raceway last year one time and it ran 11.53@117mph on 100 unleaded + alky with low boost and timing. Mike Lee built the motor and Nolan did the tuning. This truck has a LOT more in it but will need a roll cage, harness, battery box, kill switch, etc. to go faster than 11.5s at the track.

This Syclone has been a labor of love and tons of fun over the years, but it is time to pass it onto someone who will drive and enjoy it, It has been sitting covered in my garage for the last 2 years on a battery tender. I start and drive it every month and it runs flawlessly. The A/C still blows cold. This Sy has the best of everything and is extremely reliable. No expense was spared as evidenced by the list of modifications below. This is not your average Syclone and I'd like it to go to a forum member or car collector who will properly care for and appreciate it. The build is capable of 750HP+ with further tuning, timing, boost and meth. Mike, Nolan and George can vouch for the quality and effort that went into building this beast.

The truck is located in Santa Clara, CA and has 79,345 original miles. It is currently registered as non-op and will not pass CA SMOG so you will need to tow and make arrangements in your state or jurisdiction. The truck is being sold as-is and the bill-of-sale will indicate such. The truck is immaculate inside and out and has always been kept covered in my garage. It is truly one of the finest modified Syclones in existence.

I have $64K total and over $50K in parts alone invested in this truck. Clean title in hand, asking price is $32.5K.
 
Last edited:

mrweelr

New member
Re: FS: 750HP+ Sy #434 in SF Bay Area

Re: FS: 750HP+ Sy #434 in SF Bay Area

Here is the list of upgrades and new parts:

Datamaster Cable & Adaptor
NOS Center Console Plastic
Sunbrella Custom Car Cover
Chrome Fire Extinguisher
RK Custom Floor Mats
VentVisor Window Louvers
Tinted Windows (50%)
PPG Windshield
GMC Truck "Motorsports" Tailgate Decal
Kenne Bell Battery Relocation Kit
ATR Chrome Differential Cover
ATR 3" SS Exhaust
ATR Radiator Hoses
PowerMaster Chrome 200A Alternator (38203)
Painless HotShot Starter Relay (30202)
Painless 3-Circuit Fuse Block (70103)
Racetronix Dual Walbro Pump Wiring Harness
Walbro 255HP Fuel Pump (x2)
Detroit Turbo AFPR
Optima RedTop Battery
Sony M670 CD Player
Pioneer TS-P462 speakers
Kenwood KFC-415C speakers
Sony XPLOD XM-1S 4-Channel Amp
Momo Champion Steering Wheel W/Hub
LoTek 3-Gauge Pod 2 1/16"
AutoMeter CF Boost Gauge (ATM-4703)
AutoMeter CF Electric FP Gauge (ATM-4763)
Autometer CF Trans Temp Gauge (ATM-4757)
Autometer Trans Temp Send Unit
Vacuum Distribution Block
GM MEMCAL (16164174)
GM Ignition Module
GM Distributor-Coil Wire (12048976)
GM Oil Pressure Sender
GM Knock Sensor
GM IAC Valve (17112193)
GM PCV valves (8995910)
KYB Monomax Shocks
PST Front Suspension Kit
PST Idler Arm
Moog Pitman Arm
Power Performance Extreme Duty Ball Joints
Baer 13" Track Brake Kit
7/8 Rear Brake Cylinders & Raybestos 514 Shoes
Aluminum Brake Drums
ABS Delete Kit
RPM R-505 18 x 8", 18 x 9" Wheels
Kumho Ecsta MX 240/40/18 and 275/35/18 Tires
Chrome Lugnut Kit W/Locks
Belltech 3" Drop Leaf Springs (BEL-5954)
Goodmark Cowl Hood (Painted)
Checkmate FX Tonneau Cover
ACC Molded Replacement Carpet
Tahoe Mini-Starter (6449S)
MSD Pro Billet Distributor (8367)
MSD Blaster Ignition Coil (8226)
Borg-Warner Select Cap & Rotor
JS Solid Motor Mounts
Derale Trans Cooler W/Fan (13700)
Derale 180F Inline Thermostat (13021)
B&M Trans Cooler (70266)
Jegs Remote Transmission Filter (71-10678)
Blitz SBCid II Boost Controller
Dynomax SS 3" Exhaust Band Clamps
RPM EGT Probe Kit (ATM-5244)
RPM A2A Intercooler
RPM Turbo Oil Filter Kit (K&N HP1008)
3" Custom Aluminum Intercooler Tubing
Braided Hose and AN/NPT Fittings
RPM 3" Catalytic Converter
RPM Brake Booster Hose
RPM EGR Blockoff Plate
RPM 8mm Plug Wires W/MSD Separators
ITS IC-TB Transition Hose
ITS Minigate 38mm Wastegate
Thermo-Tec Exhaust Wrap, Spray Coating
DEI Fire Tape + Heat Wrap
Razor Progressive Alky Injection System
PLX Devices R-500 WBO2 Computer
DiamondBack Crystal H4 Headlamps
Sylvania SilverStar H4 Bulbs
Sylvania SilverStar H3 Fog Bulbs
Altezza Black Tail Lights
Super White Bulbs (Entire Truck)
Typhoon Mirrors
Lund Backdraft Tailgate Spoiler
TurboTime SS Radiator Support
Ramchargers Dual-Electric Fans
CBR Battle Bar Traction Bars
Edelbrock Polished Alum. Water Pump (8891)
Billet Specialties T-Stat Housing (BSP-90420)
Throttle Body Plate (Intercooled)
Throttle Body Bored 52mm, New Seals, Air Foil
Xtreme ZQ8 Steering Gear
Dorman Power Window Motors
DEI Fiberglass Plug Wire Sleeves (DEI-010502)
NGK TR6 Plugs (4177) Gapped @ .025"
March Billet Aluminum Pulleys
Spectre Magnabraid II Engine Dress-Up Kit (SPE-7498)
Billet Specialties PS Reservoir Cap (BSP-89120)
Billet Specialties Radiator Cap (BSP-75120)
AMI Billet Aluminum Master Cylinder Cover (AMIC-30001P)
ARP 12-Point Polished Stainless Engine Bolts
Hypertech 180F Thermostat
RPM Street Terror Motor (Oliver Rods, JE Extreme 9:1)
RPM Vortec Heads Package
ARP Head Studs
Cometic Head Gaskets
Engine Gaskets
Comp Cams Pro-Magnum Lifters (CCA-875-1)
Comp Cams Pro-Magnum Pushrods
Comp Cams Pro-Magnum 1.6 Roller Tip Rockers
Comp Cams Camshaft (Custom Nolan Grind)
Crane Poly Locks
PT72GTQ BB Turbo (Polished and Ceramic Coated)
RPM 1.625" SS Vortec Headers (2000F Coated)
Stage 8 STG-8951 Locking Header Bolts
QTP 3" Electric Exhaust Cutout
RPM 3" Downpipe (2000F Coated)
RPM 75# Fuel Injectors
RPM Billet Fuel Rails
RPM Custom Fuel Lines and Dual-Pump Assembly
RPM Steering Shaft
RPM Sheetmetal Valve Covers
RPM Coil-Over Front Suspension
RPM Chromoly Crossmember/Driveshaft Loop (Powdercoated)
4" 90 Degree Intake Elbows
K&N 4" Conical Air Filter (RE-0870)
K&N Engine, Tranny, Turbo Oil Filters
Summit Aluminum Overflow Tank (SUM-300100)
Moroso Aluminum PCV Catch Can
Tial 50mm BOV & Flange
S10 Replacement Radiator (No Heater Core Fitting)
B&M SFI 29.1 168-Tooth Flexplate
RPM Upper Intake Porting
RPM Powdercoat Intake Manifold
RPM Assemble Complete Motor
RPM Install Headers, Downpipe, Exhaust
RPM Redo Intercooler Piping, Install BOV Flange
RPM Fabricate Turbo Support
RPM Install Radiator, Fuel Rails, Rockers, Poly Locks
RPM Install Valve Covers, Alternator, Fuel Lines
RPM Install Turbo Drain Line, PCV, Intake
Nolan ECM Driver Mod and Custom Tune
Prime Gears Street/Strip 4l80e W/3200 Stall
TCI Electronic Trans Controller
PST Carbon Fiber Driveshaft
 
Last edited:

mrweelr

New member
Re: FS: 750HP+ Sy #434 in SF Bay Area

Re: FS: 750HP+ Sy #434 in SF Bay Area

Pictures of the truck:

P1010006.JPG

P1010007.JPG

P1010008.JPG

P1010009.JPG

P1010010.JPG

P1010011.JPG

P1010012.JPG

P1010013.JPG

P1010014.JPG

P1010015.JPG

P1010016.JPG

P1010017.JPG

P1010013.JPG
 

WyoSyclone

Active member
Re: FS: 750HP Syclone #434 in SF Bay Area

Damn, that's a gorgeous Sy Jeremy.... good luck with the sale - wish I had the cash!
 

live1053rulz

Nor Cal SyTy
Re: FS: 750HP Syclone #434 in SF Bay Area

Jeremy has been on this forum for a long time and has insanely extensive knowledge pertaining to these trucks. Not that it really needs vouching for, but I can attest to its hauling of ass, extraordinary cleanliness, and meticulous care. This truck is nuts, amazing, etc. Best of luck with your sale Jeremy, it's worth every penny.
 

nello

Active member
Re: FS: 750HP Syclone #434 in SF Bay Area

DAMN bro, I just did a quick search on craigslist and look what popped up!!

This IS the top dog Syclone as far as I'm concerned. I've never seen anything like it. Pics do absolutely no justice. Please tell me someone here has the $$$ for this beast. :bump: for the tightest of the tight.
 

sycho

New member
Re: FS: 750HP Syclone #434 in SF Bay Area

truck looks incredible!!! word of advice tho...keep it! hard to duplicate that one.
 

mrweelr

New member
Re: FS: 750HP Syclone #434 in SF Bay Area

Thanks for the complements. I'm debating whether or not I really want to sell it, but it just sits under a cover in the the garage and with my career I don't have the time to enjoy it like I used to :-( I've been thinking about selling the EVO too and just leasing a new CTS-V. I also need to free up space in my garage for the motorcycles.
 

AutoVation

Member
Re: FS: 750HP Syclone #434 in SF Bay Area

Don't sell, it's easy to replace an EVO but your Sy would be very difficult to replace.

Personally, your Sy was one of the main reasons I bought a Syclone a couple years ago. It showed me they could be made "contemporary" and not always look dated. I always wanted a Sy but didn't want to drive something too dated (after I could afford one). I ended up with the same spoiler and rims you originally had (Nello took yours lol). I would say keep it and put a few miles on it, it's not going to depreciate any further.

If you still decide to sell, don't compromise on your price.
 

nello

Active member
Re: FS: 750HP Syclone #434 in SF Bay Area

Don't sell, it's easy to replace an EVO but your Sy would be very difficult to replace.

Personally, your Sy was one of the main reasons I bought a Syclone a couple years ago. It showed me they could be made "contemporary" and not always look dated. I always wanted a Sy but didn't want to drive something too dated (after I could afford one). I ended up with the same spoiler and rims you originally had (Nello took yours lol). I would say keep it and put a few miles on it, it's not going to depreciate any further.

If you still decide to sell, don't compromise on your price.

YEah, I remember you trying to buy those wheels from me right after I picked them up. :rotf: Bro, the day he posted I was already knocking on his door. PM me some pics, I can't believe you found the "same" wheels :rant: BTW wheeler made yet another excellent wheel combo dont ya think?

:bump: bitchin truck from top to bottom. THat screw is huge and somehow he manages to keep the A/C. .:shocked!:
 

AutoVation

Member
Re: FS: 750HP Syclone #434 in SF Bay Area

YEah, I remember you trying to buy those wheels from me right after I picked them up. :rotf: Bro, the day he posted I was already knocking on his door. PM me some pics, I can't believe you found the "same" wheels :rant: BTW wheeler made yet another excellent wheel combo dont ya think?

:bump: bitchin truck from top to bottom. THat screw is huge and somehow he manages to keep the A/C. .:shocked!:

Wheeler's ride is the best balance of a street and race truck in my opinion. :tup:

On the wheels, I was tired of waiting to hear from you!:zzz: :lol:
I found some damaged wheels up in Detroit via craigslist (from an E46 M3) and had a friend refinish them and send them. It took about 6 months to make it happen since the wheels are no longer available new.
 

mrweelr

New member
Re: FS: 750HP Syclone #434 in SF Bay Area

Thanks. It's back on Craigslist today and will probably go in Truck Trader soon.
 
Top