greddy boost controller

[too many toys]

i was installing it and went to pull the connector for the controller apart and the wires on the hookup side pulled right out , there is only 2 wires in this connector so i can probobly just cut the other side off and put a new connector on it but i dont know which wires go to each other if someone has this controller and could let me know that would be F-N great its a greddy profec E-01 the wires on the controller side are pink/black the wires on the hookup side are green/white

second ? what wire do you hookup to for the rpm signal, can i tap into the white wire off the coil

 

[TYTILIDIE]

Re: greddy boost controller

That happened to me you know. I ended up somehow getting the spades out, using a pick to get the crimp open and then re-crimping it. It sucked, I also remember having to cut some of the plastic connector away.

 

[too many toys]

Re: greddy boost controller

but which wires go to which wire

pink white
--------[ ]----------
black green

 

[TYTILIDIE]

Re: greddy boost controller

but which wires go to which wire

pink white
--------[ ]----------
black green

Ill have to check for ya but it will be tomorrow so someone may beat me to it.

 

[too many toys]

Re: greddy boost controller

thanks ,do you know where i can hook into to hook up the rpm wire?