Help with fuel injector selection

Damian

Member
Re: Help with fuel injector selection

Is that due to each truck needing different injector latencies for the same 50lb injectors? Idont have a ton of experience adjusting latencies for injectors but I have done a couple. With my experience, the same injectors on two different cars required two different injectors settings. Granted this experience is on Mitsubishis, but I don't think I'm too far off on my thinking nore have I even "tuned" a SyTy yet.
 

sytyguy

Moderated User
Re: Help with fuel injector selection

We refer to latency (dead time, battcomp, etc...) as offset. We have 2 maps that pertain to offset, F92 & F94. Neither has proven effective at resolving inconsistency issues with the Delphis despite my exhaustive efforts. In fact, offset has proven little effectiveness with our tunes. Remember that we are a batch fire setup, so offset affects that bank all at once. This combined with the fact that we don't have a legitimate method of isolating and controlling offset might have something to do with it. However, I've heard of 50# Delphi fueling issues in other applications without our ECM and with sequential control.

*For those not sure what offset (latency, battcomp, etc...) is.....it is the time it takes the injector to open (and close) from the time it's energized to the time it's de-energized. Remember that an injector is nothing more than magnetic coil solenoid that opens a valve when energized, and as a result it takes time for this valve to open when the solenoid is energized. This is usually in the millisecond range, though our ECM references microseconds (our standard offset is around 580 μsec or 0.000518 of a second).
 
Last edited:

sytyguy

Moderated User
Re: Help with fuel injector selection

On a related 50# note, I have had Rich at Cruzin Performance flow match 5 sets of 50# injectors (2 of which were new) for me over the years. Each injector was significantly off in terms of flow, going on to say that each injector would flow similarly under static conditions but not necessarily under dynamic (even at 2.5 msec). I have learned to live with a larger tolerance (3-5%) on flow matching for 50s than stock or otherwise. This was also one of the reasons I moved to 60s (personally and for my customers). Our local (well, Cumming, GA) has flowed dozens of sets of MT 60s and they consistently see sets all within <1% of each other.
 

sy605

Member
Re: Help with fuel injector selection

I'm shooting for 600 when my build is done. I was told 75's are my best choice. Hope so. I already bought them. Acording to the formula 75's are perfect.
 
Top