Re: Need Measurements
I used a PAS assembly manual that I got from an ebay seller named "washere", and it should be in every sy/ty'rs library for reference. Sportmachines or someone else on here may have this manual on dvd. As far as the hardware needed. They used fixtures for locating the cups and lower brackets for drilling the holes. There are brackets on the lower section of the bed, forward of the wheel well. When Installing on a non sy/ty body, I just measured off the cladding top with the cup sitting where it would be on a good mounting point, then transferred that measurement to the body before painting. It's a bit of trial and error but maybe someone has their bed apart and can give you the measurements that you need.
