new chip ?

T

TXsyclone

Member
I bought a multichip from RPM and have a ? with the multichip and 3 bar map sensor is there any need for an aftermarket boost controller?? also would you use the sensor for the stock turbo if a aftermarket is not required and just run new vacuum lines to it??

thanks in advance
 
SY2455

SY2455

70's Veteran
Re: new chip ?

You must use the map sensor that RPM recommends. It is most likely is a 3 bar map sensor, so I would ask them. If the chip is made for a 3 bar map sensor then you cannot use the stock 2 bar map sensor. You may also need to verify your waste gate control adjustment.
 
You must log in or register to reply here.
Top