I just got down installing a Conard cap & rotor & plugs. I first put the cap and rotor on and had the firing order wrong. Then it did not start and sounds like it's backfire in the intake. Check and double check the firing order, everything is good now. I'm getting enough fuel because I can smell it. I replaced the plugs because I thought I fuel fouled them. And still no luck, please help!!
No Start after Conrad Cap & Rotor Install
- Thread starter AndrewB
- Start date
http://www.whitetyphoon.com/firing_order.html
http://www.sytyarchives.com/howto/viewarticle.php?article_name=ignition_tune_up.php&dir=engine
Check these out and make absolutely sure the wires are on correctly and are properly seated on the plugs and cap. Also make sure everything is still plugged in to the distributor and coil. If everything is definitely correct pull a plug wire and using a known good plug crank the engine and see what kind of sparking you are getting.
Just a quik WAG, its prolly something simple
http://www.sytyarchives.com/howto/viewarticle.php?article_name=ignition_tune_up.php&dir=engine
Check these out and make absolutely sure the wires are on correctly and are properly seated on the plugs and cap. Also make sure everything is still plugged in to the distributor and coil. If everything is definitely correct pull a plug wire and using a known good plug crank the engine and see what kind of sparking you are getting.
Just a quik WAG, its prolly something simple
If that's the case you should replace them again. Sorry...