AK Non-AC Heater box
- Thread starter Spnknu
- Start date
Spnknu
Member
SY2932
Administrator
Re: Non-AC Heater box
As of now, I have two available since the OP only wants one. Just to be clear what you are getting for the $100 price, I modify if for the blower resistor, clean off the old foam gasket and glass bead blast it (inside and outside). Cleaning one takes over an hour easy to do. With removing the blower motor, taping it up and blasting it too, it's really closer to two hours. I do this because there is some minor surface rust on them. I wouldn't expect anyone to install one on their truck right out of the box. I certainly wouldn't. No straight from the junkyard, spray bombed and shipped to your door going on here...
We have both FedEx and UPS accounts at my work. I can ship by whatever method you prefer. Weight for one of these is around 5.5 pounds. Shipping weight would be around 10 pounds. If you are interested, PM me you mailing address and I will get you an accurate shipping quote. Thanks.
As of now, I have two available since the OP only wants one. Just to be clear what you are getting for the $100 price, I modify if for the blower resistor, clean off the old foam gasket and glass bead blast it (inside and outside). Cleaning one takes over an hour easy to do. With removing the blower motor, taping it up and blasting it too, it's really closer to two hours. I do this because there is some minor surface rust on them. I wouldn't expect anyone to install one on their truck right out of the box. I certainly wouldn't. No straight from the junkyard, spray bombed and shipped to your door going on here...
We have both FedEx and UPS accounts at my work. I can ship by whatever method you prefer. Weight for one of these is around 5.5 pounds. Shipping weight would be around 10 pounds. If you are interested, PM me you mailing address and I will get you an accurate shipping quote. Thanks.
atkonkler
Is this your bush?
Re: Non-AC Heater box
I've done a few of these and I never had to modify the blower resistor hole at all....although I did buy a harness extension from 5todrive/Aaron....:tup:
Also had alot of issues finding the after market replacement for the blower motors ....the after market ones are clocked all wrong.....I've found only the oem ones fit best....just an fyi.
I'll be concocting a mold for a fiberglass replacement possibly so be on the watch for it in the near future!
I've done a few of these and I never had to modify the blower resistor hole at all....although I did buy a harness extension from 5todrive/Aaron....:tup:
Also had alot of issues finding the after market replacement for the blower motors ....the after market ones are clocked all wrong.....I've found only the oem ones fit best....just an fyi.
I'll be concocting a mold for a fiberglass replacement possibly so be on the watch for it in the near future!
atkonkler
Is this your bush?
SY2932
Administrator
Re: Non-AC Heater box
Yes:
"AC vs. NON AC blower motor comparison. AC fan is 3.5625" deep and NON AC is 2.750" deep."
Started cleaning these up last night, blast cabinet has been tied up with some super fine media for parts that need to get anodized.
Look to ship them out later this week. Turns out shipping stuff to Alaska pricewise, is almost like shipping overseas...
Yes:
"AC vs. NON AC blower motor comparison. AC fan is 3.5625" deep and NON AC is 2.750" deep."
Started cleaning these up last night, blast cabinet has been tied up with some super fine media for parts that need to get anodized.
Look to ship them out later this week. Turns out shipping stuff to Alaska pricewise, is almost like shipping overseas...