Re: Power is back
I can try to give a thoughtcain recepie for U.
A good cheff does start with a base before he does a dish, when the base is done he can spice it up to his/hers liking for the results wanted. Ok?.
As a base for fast runs U ned a strong bottom, (block flex ruins alot of good parts) a aftermarket/bowtie 4 bolt main block is a good foundation, V6 - V8? your preference.
Crank.. the best U can afford, throu? want to go HIGH RPM go 3,48" or less go lower RPM go 3,75" this does not differ much in power witch crank trou, U have merely determind the RPM U gona run
Pistons? realy good one aka again the best U can afford, High comp or low comp? 2 schools U desides again as early said Ed goes High Robert goes low. breakingpoint High /Low I personaly consider be 9:1
Rods, is also the best BUT its shape and material thats gona make a rod good, not the brand, H beam is the best. Lenght? to ceep cost "low" I´ll go 5,7" easy to get and all kinds of pistons is in stock and no exotic wristpin heights and so..
So now U have a expensive bottom without anny cam, heads or nothing els, so U have to focus on how much HP do U want to have?
Then go "choping around" the head department for a good and cheap head (aftermarket) that the company says meet U´r goal, read the car craft etc articles about the stout engines they display and what parts, then go hunt on E-bay or buy new U´r choise..
Cam? Do the same
Fuelinject system, I go XFI, but theres some good system out there.
Single or dual turbo setup? Once again 2 schools Ed goes dual Robert goes single, good or bad?? its about monney and setup, 2 turbos are more expencive than one but, with one U need a bigger one, and IF U goes to big U get troubble to spool it (and heres comes the trans and converter choise in as a verry importent peace of the pussle)
As Ed sais, put up the money and he builds U a copy engine BUT U wont go as fast as Ed because, U need the trans, converter, gearing, tirechoise, chassie setting AND driving style to complete copy Eds/Roberts times.
And all U gona be is Ed/Robert the II, a copycat.
U want to be famus/recognised have braggin rights for YOUR build not theres
Or U could just start from square 1 a stock Sy,
Hm what´s stopping me from go fast?? hm stock exhaust and manifolds, get me some 3" pipe and headers ..than Tune ,Tune and tune soon U gona stop at a sertan lvl. and then have to figure out whats stopping U, heads or turbo?..A slightly bigger turbo? say U goe that route and then airtemps starts to climb. and a new chois is up IC or heads, maybe U have enough money to do bouth

good do it..
But Be warned, this is a slow learning road that dont alow U to go tho the heads or turbo or parts Robert and Ed use in a finnishing stage, because those parts wont do good in this stage. just do it in a slow and small stepps route and learn how to tune out the best of every combo given.
U already know by info from Robert AND other fast going trucks that the stock intake is good up to 700+Hp so no hurry changing this.
Now U also know the Th700 will with good prep last to a 10 sec truck but when U get down here U have to consider also chassie and trans,Converter, tires and etc..
U also know Robert have tested the 3,42:1 and 3.08:1 route and sticks FOR NOW with the 3.42:1 gears
Chassie Ive told U before what an AWD is.. a combo of FWD and RWD. go figure