Rear brake line size?

Falco

Donating Member
Which connects to the proportional (?) valve. Is it 1/4" or 5/16"? The front is
3/16" but I can't find the size of the rear and I don't have the truck with me... Pls help if you can!

TIA,
 

ed hess

race or get outta the way
falco
i copied the following from my tech article on the rear brake boost control module, the rest of it is under tech articles.
hth

>>>To adapt the lines from the Launch Module to #3 AN I used Russell No
641311 7/16 24tpi #3an if (inverted flare) adapters.

To adapter the master cylinder rear wheel output I used Earls (Holly)
No 592048 9/16-18tpi if . Note that the front wheel output is a smaller size.

To adapt the combination valve IN to no #3AN I used
Earls #591932 –3AN to 7/16-24 IF into top of combination valve

To adapt the Combination valve out to #3An I used
Earls #592046 –3AN to ½-20 IF on bottom of combination valve

To adapt the Rear ABS IN to #3AN I used
Earls #591932 -AN to 7/16-24 IF into ABS unit.
 

Falco

Donating Member
Thanks Ed,

This is still not clear for me, but we will se. The different diameter brake lines
come with fixed thread sizes on the nuts, but I don't know and can't check which comes with what size. Anyway, tomorrow I'll try to hunt down
a 4x4 non ABS truck at a yunk yard, so I'll be able to measure the lines...

Later,
 

ed hess

race or get outta the way
figureing out the thread size for me was a pia.

besides all the fittings into and out of the valve were inverted flare.
hth

ed
 

Falco

Donating Member
So, I went to a yunk yard today and found a non-ABS 4x4 truck. Finally I decided to leave the whole stuff there, but I'm quite sure now, that the rear line is 1/4". Picked up a 20" line at Disconunt Auto, so I'm all set. Justification will happen when I get back to the truck again...

Thanks for your help once again,
 
Top