Does anybody know which relay is the charge air cooler pump for the turbo? I just drained the system and refilled the res. In my chilton manual It says that you have to postion a jumper wire between the A and B termials to run the pump to bleed the system. Just can't figure which relay it is? Thanks
Relay question
- Thread starter 1REDTOY
- Start date
SY2932
Administrator
Re: Relay question
Nope, the "A" and "B" terminals that are being referred to are the ones on the ALDL connector under the steering wheel. You jumper the upper right hand terminal to the one immediately to the left of it with a wire or paper clip with the ignition in the "ON" position. This is also how you can pull the "check engine" codes. If the pump doesn't run, check the fuse in the weather pack connector behind the alternator. The terminal identification and what the codes mean can be seen here. HTH's
Nope, the "A" and "B" terminals that are being referred to are the ones on the ALDL connector under the steering wheel. You jumper the upper right hand terminal to the one immediately to the left of it with a wire or paper clip with the ignition in the "ON" position. This is also how you can pull the "check engine" codes. If the pump doesn't run, check the fuse in the weather pack connector behind the alternator. The terminal identification and what the codes mean can be seen here. HTH's