So no boost reading.....

[desmo1098s]

....on stock boost gauge w/ 3 bar map? Any way to remedy this?

http://www.syty.net/forums/showthread.php?t=19837&highlight=stock+boost+gauge

I have aftermarket gauge but would like stock one to move too :lol:.

 

[Try Me]

Re: So no boost reading.....

Is the stock gauge vacuum controlled or electronic?

 

[MikeRenz]

Re: So no boost reading.....

you could run dual map sensors and wire the 2bar to the cluster

TURBO BOOST GAGE
(SYCLONE/TYPHOON)
The turbo boost gage gets its signal from the manifold
absolute pressure (MAP) sensor through the LT GRN
(432) and DK GRN (932) wires. The MAP sensor gets a
5-volt reference and a ground feed from the ECM. The
MAP sensor reads the manifold pressure and sends a
signal voltage between 0 and 5 volts to the turbo boost
gage. The voltage is proportional to the manifold
pressure.

 

[desmo1098s]

Re: So no boost reading.....

Hmmm...I think electronic? I have found NO vacuum line for it....

 

[desmo1098s]

Re: So no boost reading.....

you could run dual map sensors and wire the 2bar to the cluster

Thanks!