Stereo Wiring Question

GAShan

Donating Member
Where and how are people running wires to the cargo area in a Ty? I need to bring 3 amps worth back and want a nice clean install. Are there any shortcuts or should I just pull the back seat and rear side panels and run behind them?
 

1BADSUV

New member
HI

HI

Hi Gary,

On both Typhoon's that I installed the cabling in, I used a metal fish-tape to pull the wiring under the plastic paneling. It was pretty easy, and that was 4 AWG and 8 AWG wire, plus 3-set's of RCA's. The hardest part is when I installed a 0 AWG in a 92' Blazer and took some finesse and I had to unscrew the right-side paneling to get the 0 AWG wire through. Send me some picture's of your Typhoon.

Cheer's
Joel
 

syclonekid43

New member
i ended up pulling my back seat and front pass. side seat out . i ran the power wire on one side of the truck. the rca's on the other side. i heard if you run them all together there is a chance you might get some engine noise.
 

BPATT

New member
That is how I done mine in my typhoon. I have had a hard time with engine noise in my ty. I have been installing for years and this is the only vehicle that I have had engine noise in. I had a clarion tv/dvd with the dsp under the pass. seat. Power and rca on opposite side. I went through 3 sets of rca's. I checked my gounds over and over again. I even made sure my ground was good on my ty. I got pissed put my tv in my car but no amps or anything. It sounds good in the car. I sold all my amps (kicker 460 and 360). Then I got a new head unit, amps and subs. The same shit is going on with the noise. It is worse now because I got more powerful amps and subs. The one thing I love is I got the solobaric 12's. I love those things those things hit so hard. I hope your luck is better than mine.
 
Top