The 12 Second Recipe?

Syclone#1992

SyTy.net Moderator
These Are the things I need, I have the money now and Spring is coming :grin:!
1.Fuel pump (Walboro 242 / BBK) - $108.00
2.Fuel pressure regulator (KB, ATR, ANS, etc...) - $100.00
3.STG Ultimate Chip (needs 3 bar map sensor) - $375.00
4.Torque converter clutch switch - $5.00 Place a switch between pins A and F of the ALDL connector.
5.Good scan tool, such as DataMaster or Diacom.


I am working on the scantool, need fuel upgrade and then chip. I have the exhaust and high flow cat. I also have a cold air kit.


My question is am I heading in the right direction? I would also like to know how the
TC clutch switch works and what exactly it does. I really don't understand how the torque converter works :sad:.

Can someone also explain the timing settings on the chips? I don't understand why the timing has to be increased/decreased at higher boost levels. The STG Ultimate, also controls boost? I take it no boost controler needed then?

No flames just trying to learn and understand these mods and what they are going to do.

Bear wit me, I am new.

TIA
 

dgoodhue

BuSTeD 4.3
My question is am I heading in the right direction? I would also like to know how the TC clutch switch works and what exactly it does. I really don't understand how the torque converter works :sad:.

Can someone also explain the timing settings on the chips? I don't understand why the timing has to be increased/decreased at higher boost levels. The STG Ultimate, also controls boost? I take it no boost controler needed then?

I am no expect of TC so someone might have a better explanation than I do.

A TC use fluid properties to slip at low RPM and grabs at higher RPM. When the TC is slipping it creates more Torque multiplication (this is greta for off the line) At higher rpm, the TC does still slip a little and this creates more drivetrain loss (this hurt the top end) The TC clutch locks the TC so that it no longer slips. This is good for gas mileage and top end peformance.

Yes, the STG chip control boost so you no longer need a boost controller, if you using the stock wastegate.
 

G.D. Bryson

New member
Hey Tim. Reference your TCC questions. The switch allows the TCC to lock up immediately after shift to 2 nd (on my Ty), in effect causing a big bog on 1-2 shift. Use a wire to jump ALDL spots F to A (ground) to see if ya like it, then buy a switch.
 

tyndago

New member
That stuff is the right direction..

Most important thing is good ignition... a bad ignition can cost you a lot of power...

Open the exhaust up a bit - open the intake up a bit.

You might want to do some of the cheapskates in the 12's mods from Mike V years ago...http://www.enzoco.com/mike/syclone/

Sean
 

Syclone#1992

SyTy.net Moderator
Sean,
What do you mean by open the exhaust a little more? I have the ATR Cat and full exhaust. What do you suggest for ignition?

I want to gett into the 12's with out MAJOR mods like headers, turbo and downpipe.

Most of these seem like pretty minor mods in order to have a fast truck. If I ever wanted to return the truck to stock, it would be easy. I have access to race gas by my house too. :grin:
 
Top