Re: wipers wont turn off!
BoostedSUV said:
If I run the test light to the pink wire where the wiper switch plugs into the main harness the wipers will "park" and the switch then seems to work properly. The problem is, that causes a huge draw on voltage and the lights dim... I'm clueless at this point.
Not to sound mean or anything, But you didn't follow instructions. Look at them again. The test is to be done at the wiper motor, that is the plug you are suppose to unplug. The maximum operating current is 5.0 amps . I think you are going to find a bad circuit board as the book said if the test is not done correctly it will damaged the circuit board. If you have a spare circuit board try it.
I was looking at your problem and looking at the repair manual. What you have going on is diff than the phantom wipers. So base on that I would check these two area's.
1. One of the 3 bolts that hold the wiper motor to the firewall serves as a ground, so make sure they are tight. 10mm socket fits the bolts.
2. Check the ground above the parking brake it is really tight up there 10mm socket as well.
After you do this the manual saids the following.
CONDITION NO. 6
WPER WILL NOT SHUT OFF.
NOTICE: WHAT THIS SAYS AS IT IS IMPORTANT.
With ignition switch on, wiper switch in the off position, Remove connector from wiper terminal. Connect jumper from terminal no. 2 and no.3 and run a 12volt source to terminal no.4
Now 1of the following should happen.
1. Wiper's will go to the park position at the base of the winshield.
IF THIS HAPPENS THE COLUMN SWITCH IS BAD.
2. Wiper's still runs.
REPAIR WIPER MOTOR (CHECK PARK SWITCH ACTUATOR AND BRUSH HOLDER ASSEMBLY).
NOTE: If no.2 is the case it is faster to change out the wiper motor as the components are inside.
Let me know if this helps.:tup: