Search results

Re: Post a pic of your truck taken today Almost done just need to bleed the brakes and put it all back to one piece. I did lowering springs, QA1 shocks, JTR set back plates, wire wheeled and painted the back half of the frame, converted to C5 z06 rear disc brakes, changed out the girdle cover.

Re: Syclone QA1 rear shocks Comparing the TD801 (left) TD703 (right) before converting to eyelet on the 703 After removing the stud and screwing on the eyelet on the TD703 (right) The difference between each shock mount to mount is the that TD703 ends up being .75" shorter. I think I am...

Re: Bully Syclone at Colorado Street Outlaws Lots of nice cars. Bully Syclone looking good for the 4 seconds in the clip

Re: Syclone QA1 rear shocks Ended up having to buy an eyelet to convert the top stud in order to install the tbar. http://www.summitracing.com/parts/HAL-SS300LT I also purchased the TD801 to test fit. They have a longer compressed length 13.5" and a longer extended length 21" I imagine I'll...

Re: Syclone Gut Swap How does that non-gasket pan work? Any chance of leaks? I have a TCI pan now and was thinking of switching to a derale pan with the cooling tubes, but now that I see this mag-hytec pan it looks pretty nice. It looks like it won't fit without removing the torque converter...

Re: Syclone Gut Swap Those parts look great. Does magtech make a trans pan like that for the stock trans or just the 4L80E?

Re: Sy craigslist I didn't even realize that. Thanks for pointing it out.

Re: Sy craigslist There is no phone#. Are you sure that isn't a scam? Looks like a familiar truck from the boards here.

I've been talking with another member on he board about QA1 rear shocks he put on his Syclone. I've decided to go the same route and figure I'd pass on the info since I didn't find much on the board. QA1 offers TD901(double adj), TS901(single adjust), TN901(non adjust) which are for a standard...

Re: Newby Welcome. Good luck searching

Re: Newby My guess is somewhere in PA based on the location of the truck he looked at in this thread http://www.syty.net/forums/showthread.php?t=100778

Re: Beltech rear sway bar Same here. Now that it's all bolted in, it looks good.

Re: Beltech rear sway bar This must be a typhoon only problem. There is no way my sway bar will be hitting my leaf springs on my syclone. There is plenty of clearance.

Re: c5 z06 rear disc brakes input Update to this...I ended up cutting the bracket and adding some spacers.

Re: Brake setup question Ended up cutting the bracket I had and moving it to the inside, then spacing it with some washers...

Re: Low Mileage Syclone and Typhoon. $35,000CDN EACH Those look purty

Re: Is there any difference between c6 calipers and c5 z06 Standard C6 are the same as C5 and C5 Z06 The only difference is C5 Z06 is red. C6 Z06 are 6 piston

Re: step by step LS1 brakes how to install with pics Thanks. I figured that was correct when I slid them back in. Just wanted to be sure.

I'm going to attempt to use the brackets I have. I plan on modifying them to mount on the inside of the axle housing. I'll let you know how it turns out Sent from my iPhone using Tapatalk

Re: Rip 1gdct18z9n0811294 2003? I hope someone got parts off of that by now