Search results

Anyone else experiencing overboost at wot with turbotweek sy 3 bar velocity chip? Target boost max of chip should be close to 25 psi. I got overboost around 28 psi. Would this be normal because of the 25 psi max of the chip?

I really like your floor I really like your floor mats Wish I had some like those in my sy.

I like your floor mats What brand and where did you get them?

Does anyone have experience with best tire and wheel size for best 1/8 mile times with stock 3.42 gears,60mm turbo and 2800 stall?

👍 Thanks

I read your posts of your Syclone mods and stages from years ago and used them as a guide for me to learn,but haven't been able to pull them up again. Can you please post them again?

My truck has 110000 miles on it with turbonetics 60-1 turbo,meth injection, better cold air intake and turbotweek chip and no wide band. Test pipe with original exhaust and runs good. Also has 9-11 2800 stall converter and runs 7.90 1/8 mile Also weighs 3180 . I really enjoy it I think the...

Thanks for posting the pictures. I think they will help.

Does anyone know of a good Syclone seat cover? I would prefer a leather, but not dead set on leather. Just want them to fit tight.

Can someone please take a picture of your sy emergency brake set up when you have your truck off the ground and post it. I disconnected mine when I pulled my transmission and can't get it right.

Ok. Thanks

Does anyone know what the best and easiest 3 inch down pipe to install?

Thank you for trying to continue fabricating parts for these trucks. I really appreciate it.

Sorry for your loss. I need a scoop and torque strap

Can someone please post pics of your emergency brake set up under your truck. I removed mine and can't figure out how it goes back.

Can someone please post pics of your syclone emergency brake factory set up under the truck. I pulled my transmission and can't figure out how to put emergency brake cables back where they should go.

Idle fuel pressure is at 43 with line connected. Fuel pressure ramps up to around 68 with boost.

Meth makes up a lot for stock injectors. I just have to monitor knock closely. Make sure your sitting down. I'm running without a wide band also. Just have to shoot for mid 900's on millivolts.😁😁😁

I'm only running 23psi using 93 and can of torco to make it 104. Spraying meth with m15 nozzle wide open in 3rd gear. Stock block, stock injectors. I'm wanting to run a solid 28psi. I have seen 26psi a few times. 3.7 degrees of knock at 89mph in 3rd gear. Block is ok.

Does anyone one know if I can use a manual boost controller with factory boost controller to bleed off air to override max target boost setting on turbotweek chip. I'm trying to run 28psi boost and only getting 23psi with factory solenoid. I would really appreciate any help with this.