Search results

I'm sure there is a market for these. I was wondering if anyone out there is able to make a replacement for the Corvette stickers that inlay in the ZR1 centercaps. They are about 2 inches long and have a strip of metal on the back with 2way tape, clear on the front with the logo under a piece of...

Saw a black Ty with blueish pearl flames on the hood going south on I-25 thru Santa Fe this afternoon around 4pm. It had red Colorado plates on it and had an older fellow driving it. Nice lookin Ty, dropped and clean.

just tried searching for "hks bov" and no results... any tips?

Can someone post some pics of their A2A setup if they have a BOV?

Not a kill, but I raced an SRT10 three times this weekend - all from about a 30mph roll, he got me lagging the first time and pulled about 3 lengths before braking, second time was closer to 1 length, third time I had him by 1 length but couldn't pull away. It should be noted that he was...

is it just me?

is there any way to change the default colors scheme of the new board in our cps? also are you all planning on changing the icons to the typhoon icons the last board had? just curious :)

Well, since I pulled this off eBay I have done numerous things to it so I figured I would show 'n tell here :D When I got it it was running pretty rich and had a preignition knock. The DFI was mapped completely out of whack and needed adjusted. - Dialed in Accel gen6 - adjusted wastegate -...

I'm still figuring stuff out with the truck and I guess I have a manual boost controller in the center console, and a delta wastegate on the X-over. The PSI is maxing at about 20 currently, but how am I sure that my wastegate is working correctly? I'm not sure 100% how the wastegate works aside...

anyone know the part number for the bolts that hold the leafs onto the frame?

I was pulling out my ELC pump and replacing the air shocks tonight and I noticed my truck has a what I think is a rear sway bar installed. Its bolted on the frame and runs to the upper U-bolts on the rear axle and uses (non-stock looking) red polyurethane bushings. Do stock trucks come with...

when installing these what vacuum line plugs into it and how do you set the valve, just curious and bored at work

Do these fit over the ZR1 lugnuts or are they for a different application? http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=7941762966

Do I need a special set of shocks due to the 3-4" lowering or will the standard OEM replacement part numbers work? Are KYB Monomax or ones that are gas adjustable preferred?

Does 275/35 work all the way around? Is it necessary to run 245/40 in the front?

I know with blocks you keep the same shocks, but I was going the Belltech route and needed to know if I needed a different size shock.

When I got my truck the po had a couple of bottles of it in a box in the back. They are dated 1994 or something I think on the copyright. Does this stuff go bad or can I just shake it up and add it when I change my trans fluid?

The sticky post says "245/40R18 - 275/35 R18". What's the difference and which is better?

There is a part in front of where the stock air filter assembly goes I don't know what it is. It is black, about the size of your hand and is shaped sort of like a turbo compressor housing, except it's made out of black plastic. It bolts onto the front end beside the drivers headlamp and...

Can someone explain what the difference is in A/R ratios when looking at turbos. Which is better a low number or high number (.40, .60, or 1.10, etc)? What does it mean exactly?