Search results

  1. T

    took out A/C

    I took out my A/C for good and would like to see about getting rid of all the wires in the engine bay that goes with it... Can it be done without cutting wires??? Or will i have to cut some wires??? Jake 89 TTA 92 TY
  2. T

    looking for blower housing

    im looking for a blower housing for a non a/c S-10 blazer or truck....Took the A/C out of my TY and want to get rid of the box....But i still would like to have a the blower in it for the heater........besides a salvage yard and a dealer ship does anyone know where i can find just the housing...
  3. T

    valve body question

    What is it about the syclone typhoon valve body that is different from the other 700R4 tranny's. If i order a raptor tranny, do i need to have them use my old valve body or does it not matter. What does the valve body do differently for out trucks.
  4. T

    raptor tranny? Roadmaster tranny?

    what is everyone's opinion on tranny rebuilds.. Has anyone used the mega raptor tranny, or know of anyone who has. What about the roadmaster tranny. Does anyone know of any information on these transmissions. Would it be better to send it to john waller and have a rebuild done. What about...
  5. T

    went to the track on new build

    well i finally got the TY to the track on the new build and thought id take it easy on it so i ran 14-15psi, and didnt launch with boost........it was around 70 degrees outside at the track. where they were having a little shootout type race, no slips just times on the board, winner got...
  6. T

    hard to start

    My truck has been acting up pretty bad here lately......its hard to start it.....the only way i can get it to start is to lower the FP below what it is suppose to be stock......here are my list of mods 50 lbs inj. vortec heads comp cams cam( .500 and .510 lift) bored out .030 255 fuel pump atr...
  7. T

    bent pushrods

    is there a good way to adjust the rocker arms with a bigger cam.......i did it the stock way or the way the books all say.........but it turned out to be way to tight and bent some of my pushrods.......... thanx in advance Jake aka "OREO" 92 TY
  8. T

    boost goes up in OD

    while doing a diacom run yesterday..........i was at WOT and hitting 18 psi.....well as soon as my tranny shifted to 4th it went up to like 24-25 psi.......what could cause this........... things i have modded PTE 52 & 3" D/P High Flow 3" Cat(no Muffler) 50lbs Inj. manual boost controller ATR...
  9. T

    brake question

    how are you guys with the big cams able to hold your rear drums???.........My truck over powers the brakes with like 3-5 psi.......my brakes r stock.......and would like to get away with at least holding 7 psi.......how can i moddify the rear drums to hold better???? Jake aka "OREO" 92 TY
  10. T

    lost overdrive

    i just got my motor back together and the only thing i changed on the tranny was the TV cable......and its hooked up right..........well with 21 miles on the new motor.....the tranny wont shift to overdrive.....i can be doing 50 mph and it wont shift up into over drive.........it shifted before...
  11. T

    truck dies when shifting to reverse/drive

    ok i just installed my motor after 4 long months.........and now it seems that everytime i try to put the truck in reverse to pull it out of the garage it dies..........like its not idling up or anything.......what could this be????
  12. T

    transmission shift kit

    what shift kit would everyone reccomend for our transmissions..........I wanted to go with the Trans-Co stage 2....but seems u can only get the stage three and stage 2 in the same box.........for around $100 and i really dont want to pay for parts that im not gonna use.......(stage 3 part of the...
  13. T

    syclone spotted in tulsa oklahoma

    i was driving down mingo and saw a syclone with a female driver heading towards 81st so i followed till we got to 81st and 129th.......the truck didnt say syclone on the tailgate but it was on the ground effect on the doors....and if i remember right it had a Wisconsin dealer sticker on the left...
  14. T

    what valve springs?

    i was just wondering what valve springs to use on L35 heads.........should i use the factory ones or go with something like an LT1 like i have heard some people try??? thanx in advance
  15. T

    which lifter lifter is better

    ok im in need of some lifters and i called the autoparts stores here..........Autozone and O'reilly auto parts, they both stock them.......but autozone carries milling.........and o'reillies carries seal power.........which of these lifters would be better for our trucks????? thanx in advance
  16. T

    piston ring installation

    i ordered some federal mogul piston rings a while back and when i opened the pack today there were no instruction saying what ring went where. All i need help with is what ring goes first and what ring goes second.....cause the third is ring is simple to figure out....heh.....all i have is a...
  17. T

    need gasket numbers

    i need the intake gasket part number for the gasket used with L35 heads, or will the stock intake gaskets work???......thanx in advance
  18. T

    engine rebuild, I need part numbers and tips

    Well it has finaly come down to it...i have to rebuild my motor.......its been a fast 92K miles but the #6 cyl. wont hold compression.........o well......i need the following part numbers..... ARP Head Stud kit ARP Main Stud Kit Eagle Rods Stokes Cam K-Kit(cam, springs, seals, ect...) and what...
  19. T

    looking for new heads

    Ok im getting ready to rebuild my motor......and i was wondering what heads to use? Id like to find a direct bolt on. Do any of the newer vortec heads(94-02) bolt up directly to our block and intake manifold??? Thanx in advance for any help
  20. T

    highway run with a Supercharge TA

    friday night i was heading back from a friend of my wifes when she called me up on my cell( she drove her new jeep to show it off) and said there is a TA closing fast on you.........i say ok time to have some fun(thinking it was a punk kid) but little did i know its a guy in his lote 20's early...
Top