You have to assign the Belkin to a com port 1--4 using the Windoze device manager: (USB can assign up to port 255!)
1. Open the Windows Control Panel.
2. Select "System" - this will bring up the System Properties form.
3. Select the Hardware tab
4. Press the Device manager Button - This will bring up the Device Manager form
5. Select the Ports(Com & LPT) category. The Belkin USB serial port adapter should be present
Double-click the USB Serial Port item to bring up the properties form--
Go to the Port Settings tab and verify 9600 Baud, 8 data bits, No parity, 1 stop bit, no flow control is selected:
Next, click the Advanced button to bring up the Com port number and FIFO Buffer settings--
Make sure the Use FIFO Buffers option is selected, and then set the Receive Buffer and the Transmit Buffer settings both to 1 (one). This will give the fastest response time for the USB serial Port.
Also note the COM port number that is selected. DataMaster must match this setting, and is currently limited to COM1..4 settings.
--MAKE YOUR SELECTION HERE! If it wont allow you to select a port between COM 1 through 4, something else is using them (like an IR port or modem). In that case, you will have to use the device manager to disable one of the conflicting devices.
Occasionally, the USB serial ports do not respond the first time they are accessed after they are reconfigured. It may take a few connection tries or a system reboot for the settings to take effect.
Good Luck,
Gary