Search results

Re: Mecum Auction $17,500

Re: Thoughts on this machine work.... Doesn't look good. If it is not where the bearing rides it shouldn't affect oil pressure. I would be worried about strength. An imperfection like that could be a starting point for a crack.

Re: Another syty.net probie!!! Nice to have another Hoosier on here.

Re: Drag race poll I try to run at least once a month. Just test n tune.

Re: Forge actuator opening rates There's more factors to consider. Exhaust pressure pushing against the puck, differential pressure before and after the throttle body, amount of heat soak the preload spring can absorb before it looses tension, type of boost controller (manual or electronic)...

Re: Is this the pulsator on my sending unit?? That is a "rollover valve". Pulsator is about 1.5" long with two humps on one side, kinda like a camel.

Re: Anyone run stock wastegate and boost control setup no muf/cat? Removing the cat with a stock turbo / waste gate WILL cause boost spikes and creep. The first time it shifts into second at WOT don't be surprised when you see 25 psi or more and your engine goes pop. Try Sportmachines' Forge...

Re: Std Pistons I have 5 of my stock pistons left. They have around 70k miles on them and are in good condition.

Re: Aluminum air deflector Interested.

Re: Need To Borrow Center Cap Key I'm pretty sure that is the one I have. I'll double check.

Re: SYTY will not idle. Have you verified TDC is correct on the balancer? The outer ring can slip. I lost a fresh rebuild to this.

Re: 4 dr typhoon? Now that's a sleeper!

Re: New Member 9194 Tornado Any more info on the Dana 44?

So I was watching season 1 episode 48 of Detroit Muscle and spotted a SY. It's about 20 min. in around the Borla exhibit. Anybody?

Re: first time buyer Find a member near you to help check it out if possible. You should also find parts needed that you know about and get prices. Cladding is EXPENSIVE. Sportmachines usually has anything you could need for these trucks.

Re: Are syclones rear glass unique? Went looking for the S10 and found 2 Sonomas, both have the bronze glass in them and the same part # as Sy glass.

Re: Are syclones rear glass unique? I have to disagree, I have seen the bronze window in an S10 and another one in a Sonoma. Both trucks were 91 or newer because of the one piece grill. I haven't seen the GMC in a while but the S10 is still around so I will try to get a close up look and some...

Re: NON-Title Syclone in Missouri - Trades or best offer Interested, like to see some pics.

Re: 92 Typhoon in Indiana Nice looking Z. Congrats on the Ty :tup:

Re: Miles per gal I get 18 to 19 consistently. That's city/highway with a few "runs" thrown in.