Recent content by shook0002

Re: AC oil quantity, and 134a quantity needed I used one of the changeover kits, with PAG oil. It took 3 cans and is ice cold. I also vacuumed it for about 2 hours to make sure all the air and moisture got out.

Re: power for radio? yellow=ignition(switched) power orange=constant power

Re: Would you buy a Teal/grey? I had a teal s-10 shortbed 4x4, nicknamed the "Teal Punisher"-LOL

Re: Battle Bars & Bell-Tech 3" Springs Installed Pics Mine bottoms too with bilsteins, but I'm gonna try these Timbren things out(check link), they bolt in place of the bumpstops and are progressive. I talked to the tech guys there and sent them my measurements of the suspenion, and they said...

Re: Dash Gauges Go Crazy x-3 on grounds

Re: Palm Pilot I'd be very interested in something that runs windows based, I have an axim brand new and would like something worthwhile to do with it.

Re: More info about rear springs, rear blocks and wedges... My Ty came with 2 inch blocks on it, I put in the belltechs and the stock wedges and it was lowered the same amount.

Re: so i just got 2 JL W3s Just a suggestion, but I also have 2 JL's and I run a 800w audiobahn amp. Its clean, loud, and reliable. I think I got it for just under $200 on ebay. Its also got a volt guage on it. Its not the best amp but I just wanted something inexpensive to run. I'll post...

Re: Chrome or silver? I'm going black chrome z-06's

Re: took some pics of the gn and ty Are you on GDR also? Shoot me a pm If your serious...

Re: took some pics of the gn and ty I think you should trade the black GN for my black TY.........

Re: front diff any good used 4x4 or bravada front diff with 3:42 gears would work, with a 4x4 diff you just need to swap pass. side axle shaft and tube(easy swap).

Re: Aluminum pan and rear cover... will post em up later tonight

I just got the Trick Flow rear end cover with the studs for the bearing caps, and a new finned aluminum deep trans pan. Gonna hopefully put it this weekend, any tips from you guys? It looks pretty straightforward but just wanted to check for anything you may have encountered when doing...

Re: Small leak driving me nuts!! I got a stock cast replacement neck, its actually a lot heavier then the original one. I forgot about the right stuff-that stuff kicks ass. Its def. not the hose or the sender its coming from between the intake and neck. I'm gonna play with it again this...