Search results

Re: 10 years 8 years last month. It had just under 50,000 miles and now it's just under 100,000. Mostly stock and very reliable. I have not been able to stop the rust though.

Re: syclone in forza 4 Stock, in test drive mode so no rewind, first run on the ring, 10:29, I think, can't hardly read it on my non hd tv. Lot of room for improvement.

Re: syclone in forza 4 Me too.

Re: best turbo? I've got a 10cm so I'm not too worried about it, but it would be nice to have just to make the wastegate a little better then slightly too small with no cat.

Re: best turbo? I emailed Hahn, they have a non H, internal gate, TD06, 12cm housing for just $399. lol

Re: Noob gauging interest - Exhaust If you have a stock turbo, just make sure you have a cat. Don't gut it or replace it with straight pipe.

Re: Ohh starter ohh starter...eat my balls I'm thinking you might have to take the torque converter cover off. It's been a while, but I really don't remember it being that big of a deal.

Re: best turbo? I have a TD06 10cm housing I put on my stock turbo when my cat clogged up and I removed it. I think a TD06H 10cm, TD06 12cm, and TD06H 12cm all exist, but I'm not 100% sure.

Re: K&N directly on turbo You can run it to a catch can, and that's what you should do. Right now, both of my lines are right where they were, just open instead of connected to the air box and cross over pipe. Both lines are still dry after driving it some, so I think I'm just going to run...

Re: best turbo? Do you want to change the torque converter, or stay with the stock one?

Re: Up Graded Up Pipe? Napa radiator hose 7372 fits pretty good. List is $28, I got it for less then half that. https://www.napaonline.com/Catalog/CatalogItemDetail.aspx?A=NBH7372_0212054370&An=0

Re: K&N directly on turbo I'm thinking tbauer's filter is a better fit. R-1260

Re: K&N directly on turbo Damn man, my bad. Since the 1260 and the 1700 are the same size except for being cone vs cylinder, I thought the angle on the neck would make it fit better. Will get pics of the 1260 on the turbo tuesday.

Re: Another alternative CAC pump (pics) Looking at the pics, I just thought I would mention the way I routed my lines, and why. I ran the hose from the outlet of the pump to the lower port in the cche/lower IC, out the upper port on the cche to the higher port on the cac/upper IC, out the...

Well my cross over tube is cracking again after attempting to fix it, so to get rid of it I just got a k&n R1260 and put it straight on my stock turbo. Touches the heater hose and the radiator shroud, but it fits. K&n says the inlet ID is 2.25" / 57mm, and I measured the the od of the turbo at...

Re: Why didn't this low mile Sy bring more? Off topic I always thought the little red light above the interior light dimmer was part of my viper alarm that was installed before I bought my truck, do all of them have it, and what is it?

Re: ****..Weed is legal in CO? And you funkers didn't advertise that? Basically, the list above is what the federal .gov is allowed to do. Everything else is supposed to be up to the states. Here is my favorite example of how they justify some of the things they do...

Re: ****..Weed is legal in CO? And you funkers didn't advertise that? Only if the federal .gov has authority, which in this case, and most others, they don't. I don't see anything about drug control, so, They use general welfare, interstate commerce, and necessary and proper, to do all the...

Re: tools every SY/TY owner should have I think it is actually like $15-$20 in store. Don't know why it's so much online. How do you get an oil bottle to seal to the IC?

Re: The "End All Discussions" of 92 vs 93. AND "did some 93's have L35 heads?" Re: The "End All Discussions" of 92 vs 93. AND "did some 93's have L35 heads?" On the L35s, would it matter if the tys were not built in order? Say ty 1200 was built before ty 1000, would ty 1000 be more likely then...