Search results

You can try rockauto, or ebay with a few keywords to derive a part number and take it from there.

Just use factory rubber. Seen some poly go hard, crack and no good.

Seems like a intermittent issue. As it wasn't working, worked...and didn't work after I put fuel inside tank. Are there any other suggestions- ?

Off and on .. didn't move

I just had the tank up and down a few times when I was working on the system. I think I had intermittent connection and no ground the first time upon installing the hotwire. There's a ground lug they give you. .. , had to re-remove the tank to troubleshoot and ground everything out. Then I...

No. Been in there for awhile. Worked before. Put fuel in the truck and gauge went all the way full. I'm not sure if it's even anywhere near full. Just kind of a concern if I got for a quick spin. Not sure if it's grounding related, or just Kaputt. I replaced the fuel pump 10 years ago +-...

Noticed my fuel level is pegged full, and I believe there's less then advertised inside the tank. Is there any common fix or problem that could go wrong?

Syclone has a long shaft, and a short tail piece on the transfer case making it a longer shaft required. It also has 27 spline count. Typhoon has a shorter driveshaft and a longer tail piece on the transfer case. The spline count is 32 on the output shaft.

Yes, your going to need a 9/16 or 14mm distributor wrench. Possibly a " stubby " type of your really unsure. In the pass. Side foot well there's a brown and tan wire under the carpet where your feet go- towards the TOP/end of the carpet closest to the under dash. Pull that shit back and the...

Timing? Brown/tan wire passenger foot well. Distributors off code 42 may be EST set timing procedure

What happened?

I didn't want to take my truck distributor cap off but I'm thinking there's a gasket on the underside of the dist. Cap that could cover that portion. Can't verify it for sure but it would make sense that a gasket would be on the underside to seal the insides of the cap. I thought I had a spare...

I built mine from scratch many years back. It was a flange, and some 3 inch mandrel bends and 2 180 degree 1.5 inch stainless bends.

Must of seen it later.. like after it had started

jillD. Seen her posts early on. Not going to lie the truck looks good- surface rust on the chassis is common every place on earth has climate change from hot to cold and it's not uncommon for vehicles to change in temperature also. Unless you are all storing in climate control garage or...

I thought the yellow dot was a original. I have one I pulled out of my original truck. Maybe I'll see if it says Singapore also.

Never seen it. Is it even syclone or typhoon specific? Only thing it reminds me of is something behind the passenger seat to cover up the jack but it doesn't even really resemble that.

What gasket? Not aware of anything except for the drain connection. Turbo flange to turbo manifold was metal/metal.

Door cards.. I guess I miss understood. I thought you were referring to whole door panel. Held on by plastic screw in door clips. I guess the " door card" is further up near armrest? Never played with it. There's nuts on the back? If it's similar to the emblems I'm assuming a deep socket. I...

You could probably get away with a fork. Some type of pry bar. They make special plastic ones for similar projects.