Search results

My ty dist is a rust ball and I have a missfire. What is a good cost replacement?

Painting the ty and it is blk, blk. I see blk with grey cladding was this an option or aftermarket? I do like it and am thinking about it. Is this a bad idea?

I need fenders RH inner fender, top cap, amd tailgate. Are there any low cost vendors out there?

I have an air delete and while putting the box on I noticed the plug is different. A search on here told me this was true. I took the male end off the box and saw it had coils on it. and I assume it send a signal to the relay. I see a purple wire that runs the fan. I need a wire diagram. I...

I got a cable from a member that has one wire that goed to the truck. Does it go to M? Do I need to short any of the other ports? I did a search and saw a few different ways. http://www.syty.net/forums/showthread.php?t=21406

Or can I get it via mail?

With an emulator does the program go to a chip so the laptop can be unhooked? Or does it use the laptop to store information?

New trans started bump forward, while in park, today at the steet machine nationals. Now if placed in park the typhoon wil roll.

The idle pulley and the one on the belt tension. On the TY which one gets the larger, of the two, pulleys? To get the pulleys to line up I had to put the bigger one on the tension arm but that puts the belt CLOSE to the water pump.

Is there any way to get it loose without removing the pulley? I need to put the bolt in the block for the brackets that is behind the pump and can't do it with the pump in place.

Can the rear yoke be removed without damage to the crush seal? It has two broke bolts that I am having trouble drilling out while in place.

I tried to search and couldn't find the info I saw once before. I have the ATI set up that uses a GN turbo that is higher due to the 4 to 3 bolt adapter. This puts to ol' Turbo output about the same hight as the intercooler input. I saw part numbers here once for rad hoses that can be...

I am running a ext filter before the cooler so I need to know which of the 2 lines is out and which is in. Top or bottom.

I got a truck that has AC Delete and need a replacement pulley. It says Dayco 00163 but Dayco does not show it and O'Reilly's book does not show it either, Tim

I search but didn't ubderstand.

I can get AMSOL, is it best? Which one?

I saw on here where some run one. I was thinking on in front of cooler might save it during a trans blow. Where to get one and would it cause too much pressure? Also like the idea of pulling off it for a guage. Tim

The Ty I got came with a GN turbo from ATR and not sure how to tell whuch one it is. It has large and small blade on the impeller and a small ink mark on one blade. Any thoughts? Tim

I tried the search and didn't see anything. The TY I got has a gn turbo with the adapter plate. This moves the intake SO close to thte rad that I can't find and elbow to adapt a cleaner to. Is there a soft tube that connects and then makes a HARD 90 to put a K&N too? The battery has been moved.